Data Sheet: Kuniseal C-31Ds Waterstop
Data Sheet: Kuniseal C-31Ds Waterstop
Data Sheet: Kuniseal C-31Ds Waterstop
KUNISEAL
C-31DS WATERSTOP SELF-ADHESIVE SWELLABLE WATERSTOP
KuniSeal C-31DS is specifically designed to act as a water stop in concrete KUNISEAL C-31DS INSTALLATION INSTRUCTIONS
construc on joints, pipe penetra ons, full-bores, box-outs and for concrete
repair. It’s unique characteris cs give it long las ng durability and superior 1. Thoroughly clean and dampen Construc on Joint surface. Remove loose
waterproofing results, even when subjected to high hydrosta c pressure and aggregate, oils, debris, e clippings and carpenter’s scrap.
in marine environments. It is also quick and easy to install.
KuniSeal C-31DS is a composite product consis ng of high swelling bentonite, 2. Wet KuniSeal C-31DS to ac vate the self-adhesive film. Do NOT remove
mineral oils and modified polymers. this film!
KEY BENEFITS:
ü Fully self-adhesive - once applied stays stuck
ü No nailing & no adhesives required
ü Tested to 95m head
ü Pliable to accommodate any joint surface texture and shape
ü Adheres to PVC / HDPE and Steel
ü Also applied around pipe penetra ons and box-outs
ü Controlled ini al swell rate - no expansion stress - on site weather 3. Place KuniSeal C-31DS at centre of joint.
tolerant
ü Suitable for fresh water and marine environments
ü Permanent seal - superior results
ü Cost effec ve & economical
CONTROLLED EXPANSION
ü The specially formulated oils in KuniSeal C-31DS controls the speed of 5. Connect two lengths of KuniSeal C-31DS by pinching each length together,
swelling by limi ng how quickly water reaches the montmorillonite. This forming a bu joint without any gaps.
prevents a sudden increase in the pressure within new joints that might
otherwise damage the surrounding concrete.
NO DAMAGE TO CONCRETE
ü The bentonite in KuniSeal C-31DS does not exert excessive force on the
concrete. The wet montmorilleonite instead forms a gel which blends
into the voids in the construc on joint zone.
PERMANENT SEAL
ü Bentonite is a natural inorganic mineral that will not dissolve,
6. Ensure that once dry, KuniSeal C-31DS has adhered completely to the
disintegrate or breakdown like a plas c rubber sealant.
ü KuniSeal C-31DS, unlike other swelling sealants, is a permanent sealant. concrete.
NOTE: STORAGE:
ü KuniSeal C-31DS is designed for non-moving construc on joints only. It is Store under cover, out of direct sunlight and protect from extreme
not designed for expansion joints. temperature and moisture.
ü A minimum of 30mm of concrete cover is required in all direc ons
around applied KuniSeal C-31DS. PACKAGING:
Unit: 12(h) x 28(w) x 1,000mm (length)
Case: 20 x 1m
Weight: 9,6kg per case
DATA SHEET
KUNISEAL
C-31DS WATERSTOP SELF-ADHESIVE SWELLABLE WATERSTOP
Kuniseal C-31 DS
Kuniseal C-31 DS Minimum 30mm Cover
Mortar
Crack
Mortar
Non-Shrink Grout
Non-Shrink Grout
FULL-BORE REPAIR
MANUFACTURED BY:
Kuniseal C-31DS Waterstop Kunimine Industries Ltd
Tokyo, Japan
For more informa on on this product and other joint sealants (including expansion / contrac on joints) please contact MSASA
www.msasa.co.za | +27 (0)87 231 0253