Republic of the Philippines
Mindanao State University - Iligan Institute of Technology
College of Engineering & Technology
Department of Civil Engineering & Technology
Tibanga, 9200 Iligan City, P.O. Box No.5644 Tel. Nos. (063) 221-4050 Loc.130
Direct line (063) 2351E-mail:
[email protected] Homepage: http://www.msuiit.edu.ph/coe
CVE162 - Principles of Reinforced/Prestressed Concrete 2
S.Y. 2021-2022 First Semester
Raw score =
PRELIM EXAM
Deduction =
Net Score =
Directions:
1. Read the instructions properly.
2. Analyze each problem carefully. Calculate and present your solutions neatly and clearly. Use
long size bond paper. Draw the free body diagram as much as possible to support your
solution. For items with calculations, put your answers in the box. Make assumptions when
necessary.
3. The exam is only good for 3 hours from 9:00 am to 12:00 nn today, October 17, 2021.
However, to compensate for any problems (e.g., power interruption, poor internet
connection, etc.) that might occur during this period, there will be an allowance of 6 hours
for the submission before the deadline.
4. Whichever is smaller, a deduction of 20% of the total score or 10 points per hour late will be
penalized for late submission. No submission will be accepted beyond the exam date.
5. A maximum of 20% deduction of the total score will also be penalized for not following the
instruction and proper formatting including blur image, too many erasures, missing data
below (ID No, Name, etc.) and illegible penmanship.
6. NO credits shall be given once the submission is not an original work.
7. Only word file is permitted. If the size of the document is beyond 10 MB, two submissions
will be accepted.
8. Upload your file(s) to MOLE 3.0. Submission through email will not be accepted.
ID No: Name: Date: Sheet:
1
Republic of the Philippines
Mindanao State University - Iligan Institute of Technology
College of Engineering & Technology
Department of Civil Engineering & Technology
Tibanga, 9200 Iligan City, P.O. Box No.5644 Tel. Nos. (063) 221-4050 Loc.130
Direct line (063) 2351E-mail:
[email protected] Homepage: http://www.msuiit.edu.ph/coe
CVE162 - Principles of Reinforced/Prestressed Concrete 2
S.Y. 2021-2022 First Semester
PRELIM EXAM
Problem 1: A 500 mm x 500 mm column carries a total live load of P= [ Birthday ] ×50 kN and
a total dead load of Q= [ Birth month ] ×100 kN. The column is to be supported by a rectangular
spread footing whose width is limited to 2 m and whose bottom is 2 m below the ground surface.
Allowable soil bearing capacity at the base of the footing is 250 kPa. Unit weight of soil above
footing is 16 kN/m3 and unit weight of concrete is 23.5 kN/m 3. Assume f’c = 28 MPa and fy =
275 MPa. Assume thickness of footing to be 600 mm, determine the following:
a. Required effective depth of footing based on wide beam shear in mm. (10 pts)
b. Required effective depth of footing based on punching shear in mm. (10 pts)
c. Required number of 25-mm bars needed along short direction of footing. Provide layout.
(10 pts)
d. Required number of 25-mm bars needed along long direction of footing. Provide layout.
(10 pts) P+
Q
2.5 m 1.5
m
1m
2m
ID No: Name: Date: Sheet:
2
Republic of the Philippines
Mindanao State University - Iligan Institute of Technology
College of Engineering & Technology
Department of Civil Engineering & Technology
Tibanga, 9200 Iligan City, P.O. Box No.5644 Tel. Nos. (063) 221-4050 Loc.130
Direct line (063) 2351E-mail:
[email protected] Homepage: http://www.msuiit.edu.ph/coe
CVE162 - Principles of Reinforced/Prestressed Concrete 2
S.Y. 2021-2022 First Semester
PRELIM EXAM
Problem 2: A wall footing is subjected to axial loads and moments. Other pertinent data
are tabulated below. Design the wall footing using 2015 NSCP. Given the following data,
design the isolated rectangular footing. Make assumptions when necessary.
Axial dead load P DL = 400 kN/m
Axial live load P¿ = x kN/m
Applied dead load moment M DL = 100 kN∙m/m
Applied live load moment M¿ = 150 kN∙m/m
Compressive strength of concrete f c' = 28 MPa
Yield strength of steel fy = 375 MPa
Unit weight of concrete yc = 24 kN/m3
Unit weight of soil ys = 16 kN/m3
Allowable soil pressure qa = 250 kPa
Diameter of bars to be used db = 28 mm
Depth of foundation Df = set m
The variable x is equal to 200 + sum of your birth month and day.
a. Determine the effective soil pressure.
b. Determine the minimum width of footing such that the effective soil pressure
will not be exceeded.
c. Determine the required effective depth and the thickness of footing.
d. Determine the spacing of reinforcements.
e. Prepare the schedule of the footing design.
ID No: Name: Date: Sheet:
3
Republic of the Philippines
Mindanao State University - Iligan Institute of Technology
College of Engineering & Technology
Department of Civil Engineering & Technology
Tibanga, 9200 Iligan City, P.O. Box No.5644 Tel. Nos. (063) 221-4050 Loc.130
Direct line (063) 2351E-mail:
[email protected] Homepage: http://www.msuiit.edu.ph/coe
CVE162 - Principles of Reinforced/Prestressed Concrete 2
S.Y. 2021-2022 First Semester
PRELIM EXAM
Problem 2: A wall footing is subjected to axial loads and moments. Other pertinent data
are tabulated below. Design the wall footing using 2015 NSCP. Given the following data,
design the isolated rectangular footing. Make assumptions when necessary.
Summary of Answers:
Assigned P = _________ ; Q = _________
Part a:
Part b:
Part c: Provide drawing
Part d: Provide drawing
Problem 2: Trapezoidal Footing. A trapezoidal footing is to be designed to carry loads P 1 and P2 from Column 1
and Column 2, respectively. Each column has a size of 450 mm x 450 mm and has a center-to-center spacing of 5.48
m. The larger base coincides with the face of the column having larger load and the shorter base coincides with the
face of column having smaller load. Column 1 carries a dead load of 1, 200 kN and live load of
[ Birth month ] ×80 kN while column 2 carries a dead load of 900 kN and a live load of [ Birthday ] × 5 0 kN . f’c
= 21 MPa and fy = 400 MPa. Allowable bearing capacity of soil is 190 kPa. Depth of footing is 1.2 m. Determine the
following:
a. Dimension of the bases (5 pts)
b. Shear diagram (10 pts)
c. Moment diagram (10 pts)
d. Total depth of footing in the column that carries larger load as controlled by one – way shear (5 pts)
e. Total depth of footing in the column that carries larger load as controlled by two – way shear (5 pts)
Summary of Answers:
Assigned Col 1 PLL = _______ ; Col 2 PLL = _______
Part a:
Part d:
Part e:
Problem 3: The footing shown carries a column of P= [ Birth month ] ×100+[Birthday ]×80 kN on a column
section 600 mm x 600 mm. The load coincides with the center of piles 2, 3, 5, and 6. Neglect the weight of the
footing. Determine the load as well as the stress in each pile. Assume when necessary. (30 pts)
ID No: Name: Date: Sheet:
4
0.45 m 0.90 m 0.90 m 0.45 m
Republic of the Philippines
Mindanao State University - Iligan Institute of Technology
College of Engineering & Technology
0.45 m
Department of Civil Engineering & Technology
1 2 9200 Iligan City,3 P.O. Box No.5644 Tel. Nos. (063) 221-4050 Loc.130
Tibanga,
Direct line (063) 2351E-mail:
[email protected] Homepage: http://www.msuiit.edu.ph/coe
0.90 m
4 CVE162 5- Principles6of Reinforced/Prestressed Concrete 2
0.90 m column S.Y. 2021-2022 First Semester
7 9
PRELIM EXAM
8
0.90 m
Summary:
Assigned P = ___________
Pile Name Reaction Stress
1 R1 = q1 =
2 R2 = q2 =
3 R3 = q3 =
4 R4 = q4 =
5 R5 = q5 =
6 R6 = q6 =
7 R7 = q7 =
8 R8 = q8 =
ID No: Name: Date: Sheet:
5
Republic of the Philippines
Mindanao State University - Iligan Institute of Technology
College of Engineering & Technology
Department of Civil Engineering & Technology
Tibanga, 9200 Iligan City, P.O. Box No.5644 Tel. Nos. (063) 221-4050 Loc.130
Direct line (063) 2351E-mail:
[email protected] Homepage: http://www.msuiit.edu.ph/coe
CVE162 - Principles of Reinforced/Prestressed Concrete 2
S.Y. 2021-2022 First Semester
PRELIM EXAM
9 R9 = q9 =
The presentation of your solutions will start here.
ID No: Name: Date: Sheet:
6
Republic of the Philippines
Mindanao State University - Iligan Institute of Technology
College of Engineering & Technology
Department of Civil Engineering & Technology
Tibanga, 9200 Iligan City, P.O. Box No.5644 Tel. Nos. (063) 221-4050 Loc.130
Direct line (063) 2351E-mail:
[email protected] Homepage: http://www.msuiit.edu.ph/coe
CVE162 - Principles of Reinforced/Prestressed Concrete 2
S.Y. 2021-2022 First Semester
PRELIM EXAM
ID No: Name: Date: Sheet:
7
Republic of the Philippines
Mindanao State University - Iligan Institute of Technology
College of Engineering & Technology
Department of Civil Engineering & Technology
Tibanga, 9200 Iligan City, P.O. Box No.5644 Tel. Nos. (063) 221-4050 Loc.130
Direct line (063) 2351E-mail:
[email protected] Homepage: http://www.msuiit.edu.ph/coe
CVE162 - Principles of Reinforced/Prestressed Concrete 2
S.Y. 2021-2022 First Semester
PRELIM EXAM
ID No: Name: Date: Sheet:
8
