Scribd
Upload
144 views1 page

Disassembly: - Power Steering Vane Pump

The document provides disassembly instructions for a power steering vane pump in 9 steps. It instructs to measure the pump's rotating torque before removal, then remove components like the oil reservoir, brackets, housing, cam ring, vane plates, rotor, shaft and pulley. Gaskets and seals should also be removed from detached parts. Care is needed to avoid dropping vane plates during disassembly.

Uploaded by

salusfrank
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
144 views1 page

Disassembly: - Power Steering Vane Pump

The document provides disassembly instructions for a power steering vane pump in 9 steps. It instructs to measure the pump's rotating torque before removal, then remove components like the oil reservoir, brackets, housing, cam ring, vane plates, rotor, shaft and pulley. Gaskets and seals should also be removed from detached parts. Care is needed to avoid dropping vane plates during disassembly.

Uploaded by

salusfrank
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

SR-25

STEERING - POWER STEERING VANE PUMP


SR0VS-03

DISASSEMBLY
NOTICE:
When using a vise, do not overtighten it.
1. MEASURE PS VANE PUMP ROTATING TORQUE
(a) Check that the pump rotates smoothly without abnormal
noise.
(b) Using a torque wrench, check the pump rotating torque.
Rotating torque:
F09848
0.27 N·m (2.8 kgf·cm, 2.4 in.·lbf) or less
2. REMOVE OIL RESERVOIR
(a) Remove the 3 bolts and oil reservoir.
(b) Remove the O-ring from the oil reservoir.
3. REMOVE HEAT INSULATOR AND REAR STAY
Remove the bolt, heat insulator and rear stay.
4. REMOVE FRONT AND REAR BRACKETS
Remove the 2 bolts, front and rear brackets.
5. REMOVE PRESSURE PORT UNION, FLOW CONTROL
VALVE AND SPRING
(a) Remove the pressure port union, flow control valve and
spring.
(b) Remove the O-ring from the pressure port union.
6. REMOVE OIL PRESSURE SENSOR
(a) Remove the oil pressure sensor.
(b) Remove the O-ring from the oil pressure sensor.
7. REMOVE REAR HOUSING
(a) Remove the 4 bolts and rear housing.
(b) Remove the O-ring from the rear housing.
8. REMOVE CAM RING, 10 VANE PLATES, VANE PUMP
ROTOR AND SIDE PLATE
(a) Remove the cam ring and 10 vane plates.
NOTICE:
Take care not to drop the vane plate.
(b) Using a screwdriver, remove the snap ring, vane pump ro-
tor and side plate.
(c) Remove the 2 O-rings from the side plate.
9. REMOVE VANE PUMP SHAFT WITH VANE PUMP
PULLEY

2002 ECHO (RM884U)

Author: Date: 1085

You might also like