0% found this document useful (0 votes)
81 views2 pages

Model: L64: Operation, Maintenance & Commissioning Manual

Download as pdf or txt
Download as pdf or txt
Download as pdf or txt
You are on page 1/ 2

Operation, Maintenance & Commissioning Manual

Model: L64
Application: Outdoor Use - Wet Location - IP 65

A. IMPORTANT SAFETY PRECAUTIONS – PLEASE READ CAREFULLY


1 – Wiring Must Be Performed by a qualified and trained technician.
2 – Turn Off the Power from the PANEL BOARD (MAINS SUPPLY) Before any action while servicing or commissioning.
3 – READ CAREFULLY the product label and Confirm the INPUT VOLTAGE to the Luminaire matches the OUTPUT Voltage
your power supply.
4 – Make sure the Luminaire has COOLED DOWN before any serving or maintenance.
5- Always use anti electrostatic gloves when servicing the Luminaire.
6- Under any circumstance, do not touch the DIODE or OPEN the DRIVER as this will void the warranty and cause damage
to the Luminaire.
7- When Connecting the Main Power supply in to the Luminaire POWER INLET – MAKE SURE it is securely tight, and all.
wires are insulated and power leakage
does not exist.
8- Note that Lighting Fixture wired
incorrectly can cause short circuits
and FIRES.
9 – Ensure that you close the
cover/Box correctly and fasten the
luminaire tightly as fallen luminaries
might cause serious injuries.
10 – Under any circumstance, water
should not reach the Luminaire/Wires
if it is wet or damp location.

B. CLEANING
Cleaning of Lighting fixture is advised to be done regularly to enhance the life time and visual characteristics of the lighting
fixture. Cleaning also aids in keeping the Lumen output as at its highest level. To clean to follow the instructions below:
 Switch of the Main Power Supply from the Breaker or Control Panel.
 Allow enough time for the Lighting Fixture to cool Down.
 Cleaning should be done by mild water on a fabric cloth.
 Using a non-abrasive cleaning detergent is advised with water.
 Before closing the fixture, ensure that the Fixture is completely dry.
 Tighten all screws and safety locks firmly and Re-Connect the power for a safe commissioning.

1
C. Installation Instruction

D. SPARE PARTS & REPLACEMENT


Any parts to be replaced are to be done by a qualified electrician and to be purchased through a trusted source with the
appropriate certification. Specifications can be provided by NLC to advise which part is required, and NLC can assist in
approving the replacement spare part.

You might also like