Scribd
Upload
49 views4 pages

E&M Cable Pinouts To Connect Cisco 1750/2600/3600 E&M VIC To Nortel PBX Option 11 E&M Trunk

Uploaded by

Arp Pabmar
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
49 views4 pages

E&M Cable Pinouts To Connect Cisco 1750/2600/3600 E&M VIC To Nortel PBX Option 11 E&M Trunk

Uploaded by

Arp Pabmar
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 4

Cisco - E&M Cable Pinouts to Connect Cisco 1750/2600/3600 E&M VIC to Nortel PBX Option 11 E&M Trunk

E&M Cable Pinouts to Connect Cisco


1750/2600/3600 E&M VIC to Nortel PBX Option 11
E&M Trunk

Contents
Introduction
Prerequisites
Requirements
Components Used
Conventions
Pinout Configuration
Nortel Option 11 PBX
VIC-2E&M Pinout
NetPro Discussion Forums - Featured Conversations
Related Information

Introduction
These are the E&M Cable Pinouts used to connect a Cisco 1700/2600/3600/3700 E&M Voice Interface Card (VIC) to a Nortel PBX
Option 11 E&M Trunk.

Prerequisites
Requirements
There are no specific requirements for this document.

Components Used
This document is not restricted to specific software and hardware versions.

Conventions
For more information on document conventions, refer to the Cisco Technical Tips Conventions.

Pinout Configuration
The Nortel PBX 25 pair wire Amphenol Cable must be punched down with the standard Nortel PBX E&M punch down scheme as
seen in this list in order for the E&M Cable Pinouts to work.
Wires: 5 pairs to a group:
● White-blue, white-orange, white-green, white-brown, white-slate(grey)
● Red-b, R-O, R-G, R-B, R-S

http://kbase:8000/paws/servlet/ViewFile/8632/e_m_cab_pin.xml?convertPaths=1 (1 of 4) [4/15/2005 4:17:35 PM]


Cisco - E&M Cable Pinouts to Connect Cisco 1750/2600/3600 E&M VIC to Nortel PBX Option 11 E&M Trunk

● Black-b, B-O, B-G, B-B, B-S


● Yellow-b, Y-O, Y-G, Y-B, Y-S
● Violet-b, V-O, V-G, V-B, V-S

Nortel Option 11 PBX


Type 1; 2-wires; router to PBX -----NorTel-----
Router Pins PBX
1 -- 7
M 2 -- 6 M
3 --
R1 4 -- 4 TA
T1 5 -- 5 TB
6 --
E 7 -- 3 E
8 --
Type 1; 4-wires; router to PBX -----NorTel-----
Router Pins PBX
1 --
M 2 -- 6 M
R 3 -- 4 TA
R1 4 -- 1 RA
T1 5 -- 2 RB
T 6 -- 5 TB
E 7 -- 3 E
8 --
Type 2; 4-wires; router to PBX -----NorTel-----
Router Pins PBX
SB 1 -- 7 SB
M 2 -- 8 M
R 3 -- 4 TA
R1 4 -- 1 RA
T1 5 -- 2 RB
T 6 -- 5 TB
E 7 -- 3 E
SG 8 -- 6 SG

VIC-2E&M Pinout
The E&M voice interface card uses an RJ48S connector. The pinout depends on the PBX type and connection. This figure shows the
wiring pattern for this connector, and the lists typical configurations.
RJ48S Wiring

Note: Pins that are not used should not be connected.


E&M Pinouts

http://kbase:8000/paws/servlet/ViewFile/8632/e_m_cab_pin.xml?convertPaths=1 (2 of 4) [4/15/2005 4:17:35 PM]


Cisco - E&M Cable Pinouts to Connect Cisco 1750/2600/3600 E&M VIC to Nortel PBX Option 11 E&M Trunk

Two-Wire Four-Wire
Operation, Operation,
Type Type
Pin Signal Description 1 2 3 5 1 2 3 5
-48V
1 SB signaling SB SB SB SB
battery
Signaling
2 M-lead M M M M M M M M
input
Ring, audio
3 R R R R R
input
Ring, audio
R or
4 input/output R R R R R1 R1 R1 R1
R1
or output
Tip, audio
T or
5 input/output T T T T T1 T1 T1 T1
T1
or output
Tip, audio
6 T T T T T
input
Signaling
7 E-lead E E E E E E E E
output
Signaling
8 SG ground SG SG SG SG
return

Note: The Nortel Option11C PBX E&M Type I signaling matches the Cisco 3640 (or any other Cisco IOS gateway) Type V
signaling. For more information about the Nortel PBX and Cisco Gateway Configuration, refer to Cisco 3640 Series Gateway-PBX
Interoperability: Nortel Meridian 1 Option 11C PBX with Analog E&M Signaling.

NetPro Discussion Forums - Featured Conversations


Networking Professionals Connection is a forum for networking professionals to share questions, suggestions, and information about
networking solutions, products, and technologies. The featured links are some of the most recent conversations available in this
technology.
NetPro Discussion Forums - Featured Conversations for Voice
Service Providers: Voice over IP
Voice & Video: Voice over IP
Voice & Video: IP Telephony
Voice & Video: IP Phone Services for End Users
Voice & Video: Unified Communications
Voice & Video: IP Phone Services for Developers
Voice & Video: General

http://kbase:8000/paws/servlet/ViewFile/8632/e_m_cab_pin.xml?convertPaths=1 (3 of 4) [4/15/2005 4:17:35 PM]


Cisco - E&M Cable Pinouts to Connect Cisco 1750/2600/3600 E&M VIC to Nortel PBX Option 11 E&M Trunk

Related Information
● Analog E&M Signaling Overview
● Understanding and Troubleshooting Analog E&M Interface Types and Wiring Arrangements
● Understanding and Troubleshooting Analog E&M Start Dial Supervision Signaling
● Cisco 3640 Series Gateway-PBX Interoperability: Nortel Meridian 1 Option 11C PBX with Analog E&M Signaling
● Understanding Voice Network Modules
● Understanding E&M Voice Interface Cards
● Voice Technology Support
● Voice and IP Communications Product Support

● Recommended Reading: Troubleshooting Cisco IP Telephony


● Technical Support - Cisco Systems

All contents are Copyright © 1992-2005 Cisco Systems, Inc. All rights reserved. Important Notices and Privacy Statement.

http://kbase:8000/paws/servlet/ViewFile/8632/e_m_cab_pin.xml?convertPaths=1 (4 of 4) [4/15/2005 4:17:35 PM]

You might also like