Scribd
Upload
123 views1 page

PLC QP

This document contains questions from an exam on programmable logic controllers (PLCs) and microcontrollers. Section A contains 10 multiple choice questions testing terminology related to PLCs and microcontrollers. Section B asks to explain concepts like the pin diagram of the 8051 microcontroller and applications of PLCs. Section C requires explaining blocks of a PLC, writing a ladder logic program, describing 8051 memory organization, and giving examples of PLC instruction sets.

Uploaded by

maheshboobalan
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
123 views1 page

PLC QP

This document contains questions from an exam on programmable logic controllers (PLCs) and microcontrollers. Section A contains 10 multiple choice questions testing terminology related to PLCs and microcontrollers. Section B asks to explain concepts like the pin diagram of the 8051 microcontroller and applications of PLCs. Section C requires explaining blocks of a PLC, writing a ladder logic program, describing 8051 memory organization, and giving examples of PLC instruction sets.

Uploaded by

maheshboobalan
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

S.B.

Roll No……………………………………

PROGRAMMABLE LOGIC CONTROLLERS AND MICROCONTROLLERS


6th Exam/Electrical/EEE/5228/May’19
Duration: 3Hrs. M.Marks:75
SECTION-A
Q1. Fill in the blanks. 10x1.5=15
a. SFC stands for _________
b. Ladder logic has been developed to mimic _________ logic.
c. In _________ PLCs the input are normally built in.
d. Sinking is common ________ line.
e. ________ Instruction will allow a line to be true for only one scan.
f. ________ is a technique often used when planning a program after a written description has
been developed.
g. A microcontroller is a _________ chip computer.
h. Number of I/O ports in 8051 are _________
i. Instruction JNB stands for stands for _________
j. 8051 has two _________ bit up-counters.

SECTION-B
Q2. Attempt any five questions. 5x6=30
i. Explain the pin diagram of 8051 in detail
ii. What is PLC? Write Advantages of PLC

m
iii. What are various applications of PLC? Explain any one in detail.
iv. Difference between Microprocessor and Microcontroller
v. Design and explain 7 segment interfaces
o
. c
vi. Draw and explain the block diagram of 8051 microcontroller

r
vii. What are different types of PLC registers?

p e SECTION-C
m
p a
Q3. Attempt any three questions.

c o 3x10=30

r r .
a. With the help of block diagram, explain the function of different blocks of PLC.
b. What is ladder programming? Write a ladder program to start /stop a motor using single push

b e
switch. Green LED glows when motor is ON. Red LED glows when motor is OFF
c. Explain 8051 memory organization in detail.
p
i) Bit instructions ii) Timer instructions.
p a
d. Explain the instruction sets in PLC, give two examples in each:

b r

You might also like