Scribd
Upload
361 views1 page

Service Manual: SV01-NHX40AT03-01E NHX4000 NHX5000 ATC Adjustment of Spindle Orientation Position

This service manual provides instructions for adjusting the spindle orientation position of machine controllers. The procedure involves: 1. Executing an orientation command in MDI mode. 2. Adjusting the in-position shift amount parameter to set the drive keys parallel to the Y-axis within a tolerance of 0.1mm. 3. Returning each axis to the ATC position and verifying proper ATC operation.

Uploaded by

mahdi elmay
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
361 views1 page

Service Manual: SV01-NHX40AT03-01E NHX4000 NHX5000 ATC Adjustment of Spindle Orientation Position

This service manual provides instructions for adjusting the spindle orientation position of machine controllers. The procedure involves: 1. Executing an orientation command in MDI mode. 2. Adjusting the in-position shift amount parameter to set the drive keys parallel to the Y-axis within a tolerance of 0.1mm. 3. Returning each axis to the ATC position and verifying proper ATC operation.

Uploaded by

mahdi elmay
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

Page 1/1

SERVICE MANUAL Manual No. SV01-NHX40AT03-01E


NHX4000
Machine Controller MSX-853 Component ATC
NHX5000
Title Adjustment of Spindle orientation position

<Adjustment Procedure>

1. Execute the orientation M19 in MDI mode.

2. Set the position of the two drive keys parallel to the Y-axis by changing the value of the
parameter.

Parameter #3108 : In-position shift amount for orientation [-35999～35999 (0.01°)]

Ex.)To adjust 30degrees, “30000 “ is added to a present value.


(The direction of M3 is a positive value.)
･Measure it with a indicator after roughly Y-axis
adjustment by the eye measurement. Drive key
(Tolerance : 0.1mm or less) (Right Fig.)

3. Return each axis (X, Y, Z-axis) to ATC position


(2nd zero return position) and make sure the ATC
X-axis
operates properly. (ATC or ATC manual operation)

Take care not to interfere with the indicator etc. in


the machine when you execute ATC or orientation.
Indicator

Refer to the following manual when you rotate the ATC arm by hand (such as a ratchet
wrench) to confirm the key positioning.

･ [SV01-NHX40AT01 Rotation of ATC arm by handle and Display of arm position]

3
2
1 2011/2/15 New Version F.Yoshida
Version YY /MM /DD Changes Corrected By
Specified Production Month Approval Issued By
Machines From For Electronic
Yoshida Distribution F.Yoshida
July 2010 (No.1)
CF2165-901A-02

You might also like