Scribd
Upload
67 views3 pages

Sinx Over X

The document discusses proving that the limit of sin(x)/x as x approaches 0 is equal to 1. It uses the definition of sine as the y-coordinate of a point on the unit circle to show that as the angle θ approaches 0, the ratio of the length of the arc and the length of the opposite side both approach the value of θ, making their ratio equal to 1. Figures 1 and 2 illustrate how the arc length and opposite side length become equal as θ shrinks toward 0, allowing us to conclude that the limit of sin(θ)/θ as θ approaches 0 is 1. This technique of comparing curves to lines in limits is an important concept in calculus.

Uploaded by

waqar jamali
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
67 views3 pages

Sinx Over X

The document discusses proving that the limit of sin(x)/x as x approaches 0 is equal to 1. It uses the definition of sine as the y-coordinate of a point on the unit circle to show that as the angle θ approaches 0, the ratio of the length of the arc and the length of the opposite side both approach the value of θ, making their ratio equal to 1. Figures 1 and 2 illustrate how the arc length and opposite side length become equal as θ shrinks toward 0, allowing us to conclude that the limit of sin(θ)/θ as θ approaches 0 is 1. This technique of comparing curves to lines in limits is an important concept in calculus.

Uploaded by

waqar jamali
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 3

sin(x)

lim =1
x→ 0 x
In order to compute specific formulas for the derivatives of sin(x) and cos(x),
we needed to understand the behavior of sin(x)/x near x = 0 (property B). In
his lecture, Professor Jerison uses the definition of sin(θ) as the y-coordinate of
a point on the unit circle to prove that limθ→0 (sin(θ)/θ) = 1.
We switch from using x to using θ because we want to start thinking about
the sine function as describing a ratio of sides in the triangle shown in Figure 1.
The variable we’re interested in is an angle, not a horizontal position, so we
discuss sin(θ)/θ rather than sin(x)/x.

arc
1 sinθ length
θ =θ

Figure 1: A circle of radius 1 with an arc of angle θ.

Our argument depends on the fact that when the radius of the circle shown
in Figure 1 is 1, θ is the length of the highlighted arc. This is true when the
angle θ is described in radians but NOT when it is measured in degrees.
|opposite|
Also, since the radius of the circle is 1, sin(θ) = equals the
|hypotenuse|
length of the edge indicated (the hypotenuse has length 1).
In other words, sin(θ)/θ is the ratio of edge length to arc length. When
θ = π/2 √rad, sin(θ) = 1 and sin(θ)/θ
√ = 2/π ∼ = 2/3. When θ = π/4 rad,
∼
sin(θ) = 2/2 and sin(θ)/θ = 2 2/π = 9/10. What will happen to the value
of sin(θ)/θ as the value of θ gets closer and closer to 0 radians?
We see from Figure 2 that as θ shrinks, the length sin(θ) of the segment gets
closer and closer to the length θ of the curved arc. We conclude that as θ → 0,

1
arc
1 length
sin θ
θ =θ

Figure 2: The sector in Fig. 1 as θ becomes very small

sin θ
→ 1. In other words,
θ
sin(x)
lim = 1.
x→ 0 x
This technique of comparing very short segments of curves to straight line
segments is a powerful and important one in calculus; it is used several times in
this lecture.

2
MIT OpenCourseWare
http://ocw.mit.edu

18.01SC Single Variable Calculus


Fall 2010

For information about citing these materials or our Terms of Use, visit: http://ocw.mit.edu/terms.

You might also like