LAN (Local Area Network) : Network. Common Examples of Area Network Types Are

Download as docx, pdf, or txt
Download as docx, pdf, or txt
You are on page 1of 7

LAN (Local Area Network)

LAN – Local Area Network – usually a small network, within a small geographic area. An example of
this would be a small office, with 2 or more computers connected to the same printer. Another
example would be a school, where several computers are connected to shared resources (pronters,
faxes, etc) and are then connected to the internet or some other kind of WAN.

Also Known As: local area network


Examples:
The most common type of local area network is an Ethernet LAN. The smallest home LAN can have
exactly two computers; a large LAN can accommodate many thousands of computers. Many LANs are
divided into logical groups called subnets. An Internet Protocol (IP) "Class A" LAN can in theory
accommodate more than 16 million devices organized into subnets.

Types of Area Network


One way to categorize the different types of computer network designs is by their scope or scale. For
historical reasons, the networking industry refers to nearly every type of design as some kind of area
network. Common examples of area network types are:

 LAN - Local Area Network


 WLAN - Wireless Local Area Network
 WAN - Wide Area Network
 MAN - Metropolitan Area Network
 SAN - Storage Area Network, System Area Network, Server Area Network, or sometimes Small
Area Network
 CAN - Campus Area Network, Controller Area Network, or sometimes Cluster Area Network
 PAN - Personal Area Network
 DAN - Desk Area Network

LAN and WAN were the original categories of area networks, while the others have gradually emerged
over many years of technology evolution.

Note that these network types are a separate concept from network topologies such as bus, ring and
star.

LAN - Local Area Network

A LAN connects network devices over a relatively short distance. A networked office building, school,
or home usually contains a single LAN, though sometimes one building will contain a few small LANs
(perhaps one per room), and occasionally a LAN will span a group of nearby buildings. In TCP/IP
networking, a LAN is often but not always implemented as a single IP subnet.
In addition to operating in a limited space, LANs are also typically owned, controlled, and managed by
a single person or organization. They also tend to use certain connectivity technologies, primarily
Ethernet and Token Ring.

WAN - Wide Area Network

As the term implies, a WAN spans a large physical distance. The Internet is the largest WAN, spanning
the Earth.

A WAN is a geographically-dispersed collection of LANs. A network device called a router connects


LANs to a WAN. In IP networking, the router maintains both a LAN address and a WAN address.

A WAN differs from a LAN in several important ways. Most WANs (like the Internet) are not owned by
any one organization but rather exist under collective or distributed ownership and management.
WANs tend to use technology like ATM, Frame Relay and X.25 for connectivity over the longer
distances.

LAN, WAN and Home Networking

Residences typically employ one LAN and connect to the Internet WAN via an Internet Service
Provider (ISP) using a broadband modem. The ISP provides a WAN IP address to the modem, and all
of the computers on the home network use LAN (so-called private) IP addresses. All computers on the
home LAN can communicate directly with each other but must go through a central gateway, typically
a broadband router, to reach the ISP.

Other Types of Area Networks

While LAN and WAN are by far the most popular network types mentioned, you may also commonly
see references to these others:

 Wireless Local Area Network - a LAN based on WiFi wireless network technology
 Metropolitan Area Network - a network spanning a physical area larger than a LAN but
smaller than a WAN, such as a city. A MAN is typically owned an operated by a single entity such as
a government body or large corporation.
 Campus Area Network - a network spanning multiple LANs but smaller than a MAN, such as
on a university or local business campus.
 Storage Area Network - connects servers to data storage devices through a technology like
Fibre Channel.
 System Area Network - links high-performance computers with high-speed connections in a
cluster configuration. Also known as Cluster Area Network.
WLAN

This article is about the wireless transmission method. For the FM radio station, see WLAN-FM

The notebook is connected to the wireless access point using a PC card wireless card.

A diagram showing a Wi-Fi network

A wireless local area network (WLAN) links two or more devices using some wireless
distribution method (typically spread-spectrum or OFDM radio), and usually providing a
connection through an access point to the wider internet. This gives users the mobility to move
around within a local coverage area and still be connected to the network.

Wireless LANs have become popular in the home due to ease of installation, and the increasing
popularity of laptop computers. Public businesses such as coffee shops and malls have begun to
offer wireless access to their customers; often for free. Large wireless network projects are being
put up in many major cities: New York City, for instance, has begun a pilot program to cover all
five boroughs of the city with wireless Internet access.

Types of wireless LANs


[edit] Peer-to-peer

Peer-to-Peer or ad-hoc wireless LAN

An ad-hoc network is a network where stations communicate only peer to peer (P2P). There is
no base and no one gives permission to talk. This is accomplished using the Independent Basic
Service Set (IBSS).

A peer-to-peer (P2P) network allows wireless devices to directly communicate with each other.
Wireless devices within range of each other can discover and communicate directly without
involving central access points. This method is typically used by two computers so that they can
connect to each other to form a network.
If a signal strength meter is used in this situation, it may not read the strength accurately and can
be misleading, because it registers the strength of the strongest signal, which may be the closest
computer.

Hidden node problem: Devices A and C are both communicating with B, but are unaware of each other

IEEE 802.11 define the physical layer (PHY) and MAC (Media Access Control) layers based on
CSMA/CA (Carrier Sense Multiple Access with Collision Avoidance). The 802.11 specification
includes provisions designed to minimize collisions, because two mobile units may both be in
range of a common access point, but out of range of each other.

The 802.11 has two basic modes of operation: Ad hoc mode enables peer-to-peer transmission
between mobile units. Infrastructure mode in which mobile units communicate through an access
point that serves as a bridge to a wired network infrastructure is the more common wireless LAN
application the one being covered. Since wireless communication uses a more open medium for
communication in comparison to wired LANs, the 802.11 designers also included shared-key
encryption mechanisms: Wired Equivalent Privacy (WEP), Wi-Fi Protected Access (WPA,
WPA2), to secure wireless computer networks.

[edit] Bridge

A bridge can be used to connect networks, typically of different types. A wireless Ethernet
bridge allows the connection of devices on a wired Ethernet network to a wireless network. The
bridge acts as the connection point to the Wireless LAN.

[edit] Wireless distribution system

A Wireless Distribution System is a system that enables the wireless interconnection of access
points in an IEEE 802.11 network. It allows a wireless network to be expanded using multiple
access points without the need for a wired backbone to link them, as is traditionally required. The
notable advantage of WDS over other solutions is that it preserves the MAC addresses of client
packets across links between access points.[5]

An access point can be either a main, relay or remote base station. A main base station is
typically connected to the wired Ethernet. A relay base station relays data between remote base
stations, wireless clients or other relay stations to either a main or another relay base station. A
remote base station accepts connections from wireless clients and passes them to relay or main
stations. Connections between "clients" are made using MAC addresses rather than by specifying
IP assignments.

All base stations in a Wireless Distribution System must be configured to use the same radio
channel, and share WEP keys or WPA keys if they are used. They can be configured to different
service set identifiers. WDS also requires that every base station be configured to forward to
others in the system.

WDS may also be referred to as repeater mode because it appears to bridge and accept wireless
clients at the same time (unlike traditional bridging). It should be noted, however, that
throughput in this method is halved for all clients connected wirelessly.

When it is difficult to connect all of the access points in a network by wires, it is also possible to
put up access points as repeaters.

[edit] Roaming

Roaming between Wireless Local Area Networks

There are 2 definitions for wireless LAN roaming:

 Internal Roaming (1): The Mobile Station (MS) moves from one access point (AP) to another AP
within a home network because the signal strength is too weak. An authentication server
(RADIUS) assumes the re-authentication of MS via 802.1x (e.g. with PEAP). The billing of QoS is
in the home network. A Mobile Station roaming from one access point to another often
interrupts the flow of data between the Mobile Station and an application connected to the
network. The Mobile Station, for instance, periodically monitors the presence of alternative
access points (ones that will provide a better connection). At some point, based upon
proprietary mechanisms, the Mobile Station decides to re-associate with an access point having
a stronger wireless signal. The Mobile Station, however, may lose a connection with an access
point before associating with another access point. In order to provide reliable connections with
applications, the Mobile Station must generally include software that provides session
persistence.[6]

 External Roaming (2): The MS(client) moves into a WLAN of another Wireless Internet Service
Provider (WISP) and takes their services (Hotspot). The user can independently of his home
network use another foreign network, if this is open for visitors. There must be special
authentication and billing systems for mobile services in a foreign network. [7]

You might also like