Scribd
Upload
50 views1 page

G97 Constant Surface Speed OFF (Group 13)

G97 turns off constant surface speed mode so that the spindle speed is not automatically adjusted based on the diameter being cut. Instead, any S code entered will set the spindle speed directly in RPM. G97 cancels any previous G96 constant surface speed mode command.

Uploaded by

Ahmed Djebbi
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
50 views1 page

G97 Constant Surface Speed OFF (Group 13)

G97 turns off constant surface speed mode so that the spindle speed is not automatically adjusted based on the diameter being cut. Instead, any S code entered will set the spindle speed directly in RPM. G97 cancels any previous G96 constant surface speed mode command.

Uploaded by

Ahmed Djebbi
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

G-code, M-code, and Setting

G97 Constant Surface Speed OFF (Group 13)


This commands the control to NOT adjust the spindle speed based on the diameter of cut and cancels any G96
command. When G97 is in effect, any S command is revolutions per minute (RPM).

Page 1 of 1 pages

You might also like