Scribd
Upload
40 views1 page

G54-G59 Coordinate System #1 - #6 FANUC (Group 12) : Page 1 of 1 Pages

G-code commands G54 through G59 set user-defined coordinate systems #1 through #6 that offset axis positions, with all subsequent movements interpreted based on the new offset coordinate system. Work offsets for the coordinate systems are entered through the Active Work Offset display and additional offsets beyond the standard 6 can be set using G154.

Uploaded by

Ahmed Djebbi
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
40 views1 page

G54-G59 Coordinate System #1 - #6 FANUC (Group 12) : Page 1 of 1 Pages

G-code commands G54 through G59 set user-defined coordinate systems #1 through #6 that offset axis positions, with all subsequent movements interpreted based on the new offset coordinate system. Work offsets for the coordinate systems are entered through the Active Work Offset display and additional offsets beyond the standard 6 can be set using G154.

Uploaded by

Ahmed Djebbi
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
You are on page 1/ 1

G-code, M-code, and Setting

G54-G59 Coordinate System #1 - #6 FANUC (Group 12)


G54 - G59 codes are user-settable coordinate systems, #1 - #6, for work offsets. All subsequent references to
axes positions are interpreted in the new coordinate system. Work coordinate system offsets are entered
from the Active Work Offset display page. For additional offsets, refer to G154 Select Work Coordinates P1-P99
(Group 12).

Page 1 of 1 pages

You might also like