Design Test Instructions
Design Test Instructions
com
VLSI Training Center
Setting standards in VLSI Design
General Instructions
1. Should sit in a proper place with proper lighting.
2. Throughout the test, you should be there online through google meet by turning on the
camera keeping the distance of 2 meter so that you will be under complete visibility.
3. Design Test will be conducted through google classroom from 11:30AM to 1:00PM.
4. The solution should be uploaded immediately between 1:00 PM to 1:10 PM
5. Steps to be followed in the test though google classroom
Step 1: Open your mail & select the message sent from Prasanna. Click on join
www.maven-silicon.com Page 2
VLSI Training Center
Setting standards in VLSI Design
Step 2: After that you will be redirected to new window as shown below & click on join
Step 3: By clicking on join, you can see the assignment where question paper is uploaded.
Click on it so that you can see the question paper along with instructions.
Go through the instructions & click on the question paper.
www.maven-silicon.com Page 3
VLSI Training Center
Setting standards in VLSI Design
Step 4 : Write the answers for the question paper in an A4 sheet & upload it through the
mobile by following the below steps.
www.maven-silicon.com Page 4
VLSI Training Center
Setting standards in VLSI Design
www.maven-silicon.com Page 5
VLSI Training Center
Setting standards in VLSI Design
By selecting the camera click the photo of your answer sheet & upload it by clicking
on the tick mark
Kindly make sure the documents uploaded are readable, otherwise it will not be
accepted.
www.maven-silicon.com Page 6
VLSI Training Center
Setting standards in VLSI Design
By selcting the option add more files upload all the answer sheets by following the
above steps.
www.maven-silicon.com Page 7
VLSI Training Center
Setting standards in VLSI Design
www.maven-silicon.com Page 8