AQA Chemistry: 5 Kinetics Exam-Style Questions
AQA Chemistry: 5 Kinetics Exam-Style Questions
AQA Chemistry: 5 Kinetics Exam-Style Questions
Figure 1.1
(1 mark)
ii State and explain what has happened to the rate of this reaction at point W in
Figure 1.1.
(2 marks)
iii In terms of collision theory explain why, at a fixed temperature, the rate of this
reaction doubles when the concentration of the hydrochloric acid doubles.
(2 marks)
(1 mark)
ii Complete Figure 1.2 by drawing the shape of the reaction profile from
reactants to products for an exothermic reaction.
Show the position of the products. Show and label the activation energy.
Figure 1.2
(2 marks)
2 From AQA Chemistry Unit 2 Chemistry in Action CHEM2 June 2009 (Question1)
Sodium thiosulfate solution (Na2S2O3) reacts slowly with dilute hydrochloric acid
to form a precipitate. The rate of this reaction can be studied in the laboratory by
measuring the time (t) that it takes for a small fixed amount of precipitate to form
under different conditions. The fixed amount of precipitate is taken as the
amount needed to obscure a cross on paper.
The equation for this reaction is shown below.
Na2S2O3 + 2HCl → 2NaCl + S + SO2 + H2O
a Identify the insoluble product of this reaction that can be seen as the precipitate.
(1 mark)
b When this reaction takes place, the collision between the reacting particles
requires an activation energy. State what is meant by the term activation energy.
(2 marks)
c In terms of particles, explain why, at a fixed temperature, you might expect the
rate of this reaction to double when the concentration of sodium thiosulfate is
doubled and the concentration of hydrochloric acid remains the same.
(2 marks)
(1 mark)
(1 mark)
3 From AQA Chemistry Unit 2 Chemistry in Action CHEM2 June 2012 (Question 1)
A student carried out an experiment in the laboratory to determine the rate of
decomposition of hydrogen peroxide into water and oxygen gas.
The student used 100 cm3 of a 1.0 mol dm–3 solution of hydrogen peroxide at
298 K and measured the volume of oxygen collected.
Curve R, in each of Figures 3.1, 3.2 and 3.3, shows how the total volume of
oxygen collected changed with time under these conditions.
a Draw a curve on Figure 3.1 to show how the total volume of oxygen collected
will change with time if the experiment is repeated at 298 K using 100 cm3 of
a 2.0 mol dm–3 solution of hydrogen peroxide.
c Draw a curve on Figure 3.3 to show how the total volume of oxygen collected
will change with time if the original experiment is repeated at a temperature
higher than 298 K.
You should assume that the gas is collected at a temperature of 298 K.
(2 marks)
(1 mark)
ii Give one reason, other than the increase in rate of reaction, why the
student was able to deduce that hydrogen bromide behaves as a catalyst
in this two-step reaction.
(1 mark)
Figure 4.1
a i On Figure 4.1, sketch the distribution for the same sample of gas at a
higher temperature.
(2 marks)
ii With reference to the Maxwell–Boltzmann distribution, explain why an
increase in temperature increases the rate of a chemical reaction.
(2 marks)
b Dinitrogen oxide (N2O) is used as a rocket fuel. The data in Table 4.1 show
how the activation energy for the decomposition of dinitrogen oxide differs
with different catalysts.
2N2O(g) → 2N2(g) + O2(g)
Table 4.1
Ea / kJ mol–1
Without a catalyst 245
With a gold catalyst 121
With an iron catalyst 116
With a platinum catalyst 136
i Use the data in Table 4.1 to deduce which is the most effective catalyst
for this decomposition.
(1 mark)
(2 marks)
5 From AQA Chemistry Unit 2 Chemistry in Action CHEM2 June 2011 (Question 1)
The rate of a chemical reaction is influenced by the size of the activation energy.
Catalysts are used to increase the rates of chemical reactions but are not used
up in the reactions.
a Give the meaning of the term activation energy.
(2 marks)
(2 marks)
Figure 5.1
To answer the questions c i to c iv, you should use the words increases,
decreases or stays the same. You may use each of these answers once,
more than once or not at all.
i State how, if at all, the value of the most probable energy (Emp) changes
as the total number of molecules is increased at constant temperature.
(1 mark)
ii State how, if at all, the number of molecules with the most probable
energy (Emp) changes as the temperature is decreased without changing
the total number of molecules.
(1 mark)
iii State how, if at all, the number of molecules with energy greater than the
activation energy (Ea) changes as the temperature is increased without
changing the total number of molecules.
(1 mark)
iv State how, if at all, the area under the molecular energy distribution curve
changes as a catalyst is introduced without changing the temperature or
the total number of molecules.
(1 mark)