Scribd
Upload
535 views

Ansoft Designer-Tutorial

This document provides instructions for setting up a circuit design project in Ansoft Designer, including adding layers for the ground, dielectric, and trace materials, selecting the appropriate materials for each layer from the material library, and setting the thickness of the dielectric and trace layers.

Uploaded by

camilo
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
535 views

Ansoft Designer-Tutorial

This document provides instructions for setting up a circuit design project in Ansoft Designer, including adding layers for the ground, dielectric, and trace materials, selecting the appropriate materials for each layer from the material library, and setting the thickness of the dielectric and trace layers.

Uploaded by

camilo
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 5

Ansoft Designer Tutorial

1. Open Ansoft Designer

2. Click Project/Insert Circuit Design

3. Click ‘None’
4. Click Schematic/Layout Stackup

5. Click “Add Layer”


6. Name: Ground
Type: MetalizedSignal

7. Repeat steps 5-6, for:


Name: Dielectric
Type: Dielectric

Name: Trace
Type: Signal
8. Change the material for the Dielectric layer
a. Click on “Rogers R…”
b. Select “Add Material…”

c. Enter values for Dielectric Layer


d. Click ‘Ok’ twice
9. Check materials for the Trace and ground layers. (Copper unless otherwise
specified) If it is different, repeat Step 8 for each material.
10. Change the Thickness of the Dielectric and Trace layers to the specified values.
(0.675mil and 31mil are standard for the Rogers Duriod 5870)

11. Select ‘Ok’

You might also like