Syllabus 2014 Lecturer Mech
Syllabus 2014 Lecturer Mech
1. THERMODYNAMICS:
Heat, work and temperature, First and Second and Zeroth law of thermodynamics and their
applications, Carnot, Otto, Diesel and Dual cycles, Properties of steam, Vapour power cycles like
Rankine, modified Rankine and Reheat cycle, Regenerative cycle.
2. HEAT TRANSFER:
Steady state one dimensional heat conduction, convection and radiation, Introduction to thermal
boundary layer, Heat exchanger, Boiling and condensation, Boilers, its mountings and accessories.
4. ENVIRONMENTAL ENGINEERING.
Refrigeration Cycle, Vapour compression and Vapour absorption cycle, Properties of important
Refrigerants, Psychrometric process, Application of Air conditioning, Human comfort.
5. AUTOMOBILE ENGINEERING
Transmission System – Clutch, Gear-box, Propeller Shaft, Differential, Brakes, Braking system,
Steering system, Air pollution by Automobile Engines and its controls, Suspension system,
Aerodynamic design of vehicle body, various safety features, Fuel System.
7. FLUID MECHANICS
Basic definitions and fluid properties, Continuity equation, Bernoullis theorem, Flow through pipes,
Laminar and Turbulent flow, Application of momentum equation, Boundary layer and its control,
Measurement of flow by Venturimeter ,V-notch and Pitot tube, Dimensional analysis.
8. FLUID MACHINES
Pelton, Francis and Kaplan turbine, their construction, performance and characteristics, Axial,
Centrifugal and Reciprocating compressors and pumps, Cavitation in pumps, Aerodynamic design of
blades, Selection of Pumps and Turbines.
1
9. MECHANICS OF SOLIDS:
Simple stress and strain, Hookes law, Bending moment and Shear force diagram, Torque and
Torsion. Elastic and Plastic deformations, Fatigue and fracture, Theories of failure, Engineering
materials.
11 MACHINE DESIGN
Design of machine elements subjected to direct stress, Design of members subjected to bending,
torsion like beam, spring, laminated spring. Design of shaft, coupling, Gear, thick and thin cylinder.
CAD, Introduction to Computer Graphics, 2D and 3D Modelling and Transformations.
*****
Pattern of Question Paper
1. Objective type paper
2. Maximum marks- 100
3. Number of questions 100
4. Duration of paper - 2 hours
5. All question carry equal marks
6. There will be negative marking
*****