Scribd
Upload
71 views2 pages

Capillary Tube Thermostat, 16 A: Technical Data

The KRM capillary tube thermostat is a mechanical temperature controller housed in a polyester enclosure. It has a switching capacity of 16A at 400V and uses a capillary tube and diaphragm to sense temperature changes that activate a microswitch to energize or de-energize connected equipment. It can control temperatures from 0-100°C or 0-300°C and is IP65 rated for weatherproof use in controlling heaters and other loads.

Uploaded by

safia mohamed
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
71 views2 pages

Capillary Tube Thermostat, 16 A: Technical Data

The KRM capillary tube thermostat is a mechanical temperature controller housed in a polyester enclosure. It has a switching capacity of 16A at 400V and uses a capillary tube and diaphragm to sense temperature changes that activate a microswitch to energize or de-energize connected equipment. It can control temperatures from 0-100°C or 0-300°C and is IP65 rated for weatherproof use in controlling heaters and other loads.

Uploaded by

safia mohamed
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 2

KRM Capillary tube thermostat, 16 A

• 16 A switching capacity Technical data


• Compact enclosure Temperature setting range 0 °C to +100 °C 0 °C to +300 °C

• Double units are standard Rated voltage AC 400 V/50 Hz AC 400 V/50 Hz
Switching capacity AC 230 V/16 A AC 230 V/16 A
AC 400 V/10 A AC 400 V/10 A
Supply cable, cross section 2.5 mm² 2.5 mm²
Protective earth terminal 4 x 2.5 mm² 4 x 2.5 mm²
Switching differential approx. 3 K approx. 8 K
Protection class IP 65 IP 65
according to EN 60529
The weather-proof capillary tube thermostat, KRM, is a mechanical change-over
controller housed in a polyester enclosure. Heaters, fans, motors and other Capillary tube length 1600 mm 1600 mm
equipment are energised and de-energised when temperatures fall below or Min. bend radius 20 mm 20 mm
rise above certain limits. It can also be used to control the temperature in air, Max. sensor temperature +115 °C +345 °C
liquids and on various surfaces.
Min. sensor temperature -40 °C -15 °C
Function Sensor diameter 6 mm 4 mm
Any change in temperature at the sensor causes a change in the volume of fluid
in the measuring system, which in turn results in a movement of the diaphragm Sensor length 140 mm 165 mm
membrane. This membrane is connected to a mechanical device that activates Sensor material SS SS
a microswitch. If the temperature at the sensor bulb exceeds the pre-set value, Cable glands 1 x M25, clamping range 9 to 16 mm
terminals 1 and 2 are opened. If the temperature falls below the minimum 1 x M20, clamping range 6 to 12 mm
setting, the contacts automatically close.
Cable glands KRM, single 1 x M25, 1 x M20 1 x M25, 1 x M20
Application example
KRM combination 1 x M25, 2 x M20 1 x M25, 2 x M20
The KRM thermostat can directly switch temperature-dependent equipment loads
(2 x M20 blanking (2 x M20 blanking
(heaters etc.) of up to 16 A. Higher switching currents of 3-phase applications
plug included) plug included)
are switched by means of a contactor.

9494 BARTEC 03-0330-0255-08/2017-EHT-202002/1


KRM Capillary tube thermostat, 16 A
M

Dimensions (mm) Circuit diagram Dimensions (mm)


KRM, single KRM, double
122 220

120
120

ϑ actual < ϑ setpoint => NC 1 - 4


ϑ actual > ϑ setpoint => NO 1 - 2

Typical installation

Mains supply
cable
2

Ordering information
Designation Dimensions (mm) Temperature setting range Order no.
1 thermostat in polyester enclosure GRP 122 x 120 x 90 0 °C to +100 °C 27-6AA3-61522000
1 thermostat in polyester enclosure GRP 122 x 120 x 90 0 °C to +300 °C 27-6AA3-615B2000
2 thermostats in polyester enclosure GRP 220 x 120 x 90 2 x 0 °C to +100 °C 27-6AK3-61622000
2 thermostats in polyester enclosure GRP 220 x 120 x 90 2 x 0 °C to +300 °C 27-6AK3-616B2000
2 thermostats in polyester enclosure GRP 220 x 120 x 90 1 x 0 °C to +100 °C 27-6AK3-61602P2B
1 x 0 °C to +300 °C
Technical data subject to change without notice.

03-0330-0255-08/2017-EHT-202002/2 BARTEC 95

You might also like