100% found this document useful (2 votes)
1K views5 pages

ECEA112 M3 Practice Quizzes

In synchronous time-division multiplexing, if a source does not have data to send, the corresponding slot in the output frame is left empty. Digital multiplexing is based on the principle of independent symbols from two or more digital signals. Multiplexing uses multiple channels and a single path.

Uploaded by

Julia Guinto
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
100% found this document useful (2 votes)
1K views5 pages

ECEA112 M3 Practice Quizzes

In synchronous time-division multiplexing, if a source does not have data to send, the corresponding slot in the output frame is left empty. Digital multiplexing is based on the principle of independent symbols from two or more digital signals. Multiplexing uses multiple channels and a single path.

Uploaded by

Julia Guinto
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 5

ECEA112 M3 Practice Quizzes

(Week 9)
1. In synchronous time-division multiplexing, if a source does not have data to send, the
corresponding slot in the output frame is
- Considered an error and has to call retransmission
- Used by another source that has data to send
- Left empty
- Removed and replaced with another slot
2. Each narrowband channel is converted to a different location in the total frequency
spectrum
- Frequency division multiplexing
- Wavelength division multiplexing
- Frequency distribution multiplexing
- None of the above
3. It is a level in an analog hierarchy where it has a bandwidth of 2.2MHz
- Jumbo group
- Group
- Master group
- None of the above
4. It is a dial-up service most often encountered when using a home telephone. It uses two-
wire (or four wire) twisted pair to connect the subscriber’s handset to the network via an
exchange. The connection is often called local loop.
- Analog switched service
5. Digital multiplexing is based on the principle of ___ from two or more digital signals
- Interdependent symbols
- Independent symbols
- Interleaving symbols
- Intermediate symbols
6. In statistical time division multiplexing, slots are dynamically allocated to
- For faster transmission time
- Prevent interference of signals
- Increase the rate of transmission
- Improve the bandwidth efficiency
7. Which of the following is not a common application of frequency division multiplexing?
- Television broadcasting
- Local area network
- AM and FM broadcasting
- Cellular telephone system
8. How many voice channels are multiplexed in a T2 line?
- 96
- 12
- 24
- 48
9. Four 1kbps connections are multiplexed together. A unit is 1 bit. Find the duration of a
frame.
- 1000sec
- 1ms
- 250usec
- 4ms
10. Four 1kbps connections are multiplexed together. A unit I 1 bit. How many slots are there
in each frame?
- 4
- 2
- 3
- 1
11. Four 1kbps connections are multiplexed together. A unit I 1 bit. Find the duration of a
timeslot
- 1ms
- 4ms
- 1000sec
- 250usec
12. Which is not true about synchronous time division multiplexing?
- Synchronous TDM can be seen as two fast rotating switches…
- In synchronous TDM, the multiplexer combines light signals using a fiber channel…
- In synchronous TDM, the data rate is n time faster…
- In synchronous TDM, digital and analog data are combined in to one timeshared link.
13. It is the process of receiving single signal and produces output on multiple channels
simultaneously
- Demodulation
- Modulation
- Demultiplexing
- Multiplexing
14. An analog multiplexing technique where the optical fiber data rate is higher than the data
rate of metallic transmission cable. It is also used to combine optical signal.
- FDM
- WDM
- CDMA
- TDM
15. Which statement is correct?
- Multiplexing uses multiple channels and multiple paths
- Multiplexing uses multiple channels and a single path
- Multiplexing uses a single channel and multiple paths
- Multiplexing uses a single channel and single path
16. It is a 6.312 Mbps service where it can be used as a single service for 6.312 Mbps
transmission or can be used to multiplex 4 DS-1 channels, 96 DS-6 channels or a
combination of this type.
- DS-4
- DS-3
- DS-2
- DS-1
17. Offers customers the opportunity to lease a line that is permanently connected to another
customer. Although the connection still passes through switches in the telephone
network, subscribers experience it as a single line because the switch is always closed, no
dialing needed.
- Analog leased service
18. Compute for the guard band in between channels in a master group with 2.52MHz total
bandwidth.
- 200.33
19. A jumbo group is equivalent to how many master group
- 6
20. FDM uses ___modulation
- Single sideband suppressed carrier
- Double sideband full carrier
- Single sideband reduced carrier
- Double sideband suppressed carrier
(Week 10)
1. Which of the following is not an advantage of spreading the bandwidth?
- Immunity from noise and multipath distortion
- Several uses can share same higher bandwidth with little interference
- Can hide / encrypt signals
- Signals after spreading can travel a much farther distance
2. Using DSSS, determine the resulting binary code of the transmitted signal
Data input: 0 1 0 0 1
PN bit stream: 0110 1001 0110 1011 0101
- 0110 0110 0110 1011 1010
3. An alternative approach that is similar to ADSL, uses coaxial fiber-optic or twisted pair
cable for short distances (300 to 1800 meters)
- SDSL
- High bit rate DSL
- Very high bit rate DSL
- RADSL
4. Asymmetric digital subscriber line divides the bandwidth of a twisted pair cable (1 MHz)
into 3 bands. Which band is used for downstream communication?
- (250KHz – 1Mhz)
- 200KHz – 2MHz
- (25-200KHz)
- (0-25KHz)
5. High bit rate DSL uses what type of encoding
- HDB3
- B8ZS
- Manchester
- 2B1Q
6. In tis technique, each bit is represented by multiple bits using a spreading code
- Time division multiple access
- Code division multiple access
- Frequency hopping spread spectrum
- Direct sequence spread spectrum
7. A multiplexing technique used with spread spectrum
- CDMA
- WCDMA
- FDMA
- TDMA
8. Which is true about symmetric (single line) digital subscriber line (SDSL)
- Same as HDSL but uses one single pair twisted cable…
- Designed by Telcordia as an alternative to the T1 line
- A technology based on DSL, allows different data rates…
- A communication technology in which the downstream data rate is higher than…
9. A technology that uses existing telecommunication networks to accomplish high speed
delivery of data, voice, and multimedia
- Multiple access
- DSL
- Spread spectrum
- Multiplexing
10. Which is not true about FHSS?
- Eavesdropper hears unintelligible blips
- Signal is broadcast over seemingly random series of frequencies
- Receiver hops between frequencies in sync with transmitter
- Each bit is represented by multiple bits using a spreading code

You might also like