Scribd
Upload
50 views

Assignment 2 - Problems On Coplanar General Force System

The document describes 5 problems involving determining the resultant force of systems of coplanar forces. Each problem provides the forces acting in a diagram and asks the learner to calculate the magnitude, direction, and point of application of the resultant force with respect to a given point.

Uploaded by

meet jain
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
50 views

Assignment 2 - Problems On Coplanar General Force System

The document describes 5 problems involving determining the resultant force of systems of coplanar forces. Each problem provides the forces acting in a diagram and asks the learner to calculate the magnitude, direction, and point of application of the resultant force with respect to a given point.

Uploaded by

meet jain
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 2

SYSTEM OF COPLANAR FORCES

1.1 GENERAL FORCE SYSTEM

1 For given system find resultant & its point


of application with respect to point O on
the x-axis (X intercept). Force, along CA =
100 N, along OD = 250 N, along ED = 150
N, along OE = 100 N. An clockwise
moment of 5000 N-cm is also acting at the
point O.
(R = 341.41 N, θ = 64.786˚, xi = 17.237
cm)

2 The forces acting on 1 m length of a dam


are shown in figure. Determine the
resultant force acting on the dam. Calculate
the point of intersection of the resultant
with the base.
(R = 137.12 N, θ = 79.92˚, x = 3.09 m)

3 Four forces & a couple are acting on a plate as shown in figure. Determine the resultant force & locate it
with respect to point A.

(R = 305.28 N, θ = 31.6, x = 0.475 m, y = 0.292 m, d = 0.249 m)

4 A system of forces acting on a bell crank is as shown. Determine the magnitude, direction & the point of
application of the resultant w.r.t. ‘O’.

Green – University Questions


(R = 2671 N, θ = 84.58˚, xi = 141.19 mm)
5 Replace the force system as shown in figure by a single force with respect to point C.
(R = 22.36 N, θ = 26.57˚, xi = 35m from 35m towards right)

Green – University Questions

You might also like