Scribd
Upload
53 views2 pages

Lab Exercise No. 5 Mesh Analysis: Danica Marie Dumalagan, Kristoffer John Giganto, Jhury Kevin Lastre

This document describes a lab exercise on mesh analysis. The exercise involved using mesh analysis on a circuit diagram with two loops. Kirchhoff's Current Law (KCL) was used to write equations for the two mesh currents. Cramer's rule was then used to calculate the theoretical values of the mesh currents. The results were analyzed and conclusions were discussed.

Uploaded by

Kristoffer John Giganto
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
53 views2 pages

Lab Exercise No. 5 Mesh Analysis: Danica Marie Dumalagan, Kristoffer John Giganto, Jhury Kevin Lastre

This document describes a lab exercise on mesh analysis. The exercise involved using mesh analysis on a circuit diagram with two loops. Kirchhoff's Current Law (KCL) was used to write equations for the two mesh currents. Cramer's rule was then used to calculate the theoretical values of the mesh currents. The results were analyzed and conclusions were discussed.

Uploaded by

Kristoffer John Giganto
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 2

Lab Exercise No.

5
Mesh Analysis
Danica Marie Dumalagan, Kristoffer John Giganto, Jhury Kevin Lastre
Department of Computer Engineering
School of Engineering, University of San Carlos
Nasipit, Talamban Cebu City, Philippines
[email protected], [email protected], [email protected]

Abstract—

Keywords-component;

I. INTRODUCTION

III. RESULTS AND ANALYSIS

II. PROCEDURE

1. For the first part of the experiment, the schematic


diagram in Figure 3 was used. Mesh analysis has
been observed to be applicable. E1, R1, R2, and E2
in the first loop, and E2, R2, and R3 in the second
loop, can be used to define two mesh currents.

2. Using KCL, the two loops were formulated to


equations. The left loop and right loop were
expressed in equation (2.1) and equation (2.2)
respectively.

11500i1 – 6800i2 = -5V Equation (2.1)

-6800i1 + 16800i2 = 15 Equation (2.2)

3. The theoretical values of the mesh currents i 1 and i2


were calculated using Cramer’s rule and recorded
using the equation above.
IV. DISCUSSION AND CONCLUSION 2021, from https://www.allaboutcircuits.com/textbook/direct-
current/chpt-2/voltage-current-resistance-relate/.

[2] AZUMAH, D. R., & *, N. (2015, April 30). A brief on


kirchhoff's laws with circuit diagram. ElProCus. Retrieved September 21,
2021, from https://www.elprocus.com/kirchhoffs-laws-working-formula/.

[3] Ivan Designostrom. (2019, June 15). Kirchhoff’s Laws. Kirchhoff’s Laws.
REFERENCES https://www.cpp.edu/%7Eelab/projects/project_02/index.html

[1] Ohm's law - how voltage, current, and resistance relate: Ohm's law:
Electronics textbook. All About Circuits. (n.d.). Retrieved September 11,

You might also like