Scribd
Upload
85 views2 pages

Replacing A Fabric Interconnect

The document outlines the 11 high-level steps to replace a fabric interconnect in a Cisco UCS cluster, including connecting the new interconnect, configuring it as a standalone device, upgrading its software to match the existing cluster member, connecting it to the existing member, adding it to the cluster through the setup wizard, and verifying successful failover between the interconnects.

Uploaded by

Dale Harding
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
85 views2 pages

Replacing A Fabric Interconnect

The document outlines the 11 high-level steps to replace a fabric interconnect in a Cisco UCS cluster, including connecting the new interconnect, configuring it as a standalone device, upgrading its software to match the existing cluster member, connecting it to the existing member, adding it to the cluster through the setup wizard, and verifying successful failover between the interconnects.

Uploaded by

Dale Harding
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 2

Replacing a Fabric Interconnect is not hard really, you just need to make sure its done right to make

the
changeover go smoothly. The high-level steps are as follows:

1. connect the new FI to the network (do not connect the L1 and L2 cables)

2. console into the new FI and run through the setup wizard configuring the new FI as a “standalone”
fabric interconnect

3. Assuming the new fabric interconnect is not at the same code level as the current FI, open your
internet browser and connect to the IP address assigned to the new FI, login as admin, and upload the
UCS code that is installed on the cluster member.

4. Still connected to the new FI, update both UCS Manager and the Fabric Interconnect to the code
running on the existing cluster member.

5. Once the upgrades are complete, verify the Running and Startup versions match those of the existing
cluster member.

6. Console into the new fabric interconnect and run the following commands:

:connect local-mgmt

:erase configuration

:yes (to reboot)

7. Connect the L1 and L2 cables to the existing fabric interconnect

8. Console into the new fabric interconnect and run through the setup wizard. When the setup wizard
detects the presence of a peer Fabric interconnect, type y to add the new FI to the existing cluster. Save
the configuration and reboot the new FI.

9. Login to UCS Manager or use the command line to verify the cluster state.
10. Test failover. In this example, I use the command line on Fabric-B as Fabric-A was the “new” fabric
interconnect. From the command line of Fabric-B, enter the following commands:

:connect local-mgmt

:show cluster state (verify B is still the primary)

:cluster lead a (makes Fabric-A the primary)

:show cluster state (if done quickly, you’ll see the status of SWITCHOVER IN PROGRESS)

11. Login to UCS Manager once again to verify the failover is seen in the GUI and you are done.

You might also like