Scribd
Upload
4K views1 page

Mould Loading Unloading System

The document outlines a mould loading and unloading system procedure. The procedure involves the mould setter checking the mould change plan, readiness of the mould, raw materials, ejector movement, and loading the mould. The mould setter also takes the first shot, locks the mould, cleans it, and records any feedback during production runs before unloading the mould.

Uploaded by

RAHUL YADAV
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as XLSX, PDF, TXT or read online on Scribd
4K views1 page

Mould Loading Unloading System

The document outlines a mould loading and unloading system procedure. The procedure involves the mould setter checking the mould change plan, readiness of the mould, raw materials, ejector movement, and loading the mould. The mould setter also takes the first shot, locks the mould, cleans it, and records any feedback during production runs before unloading the mould.

Uploaded by

RAHUL YADAV
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as XLSX, PDF, TXT or read online on Scribd
You are on page 1/ 1

Doc No.

MOULD SETUP SYSTEM Eff. Date


Rev. No.
Mould Loading - Unloading system takes care of:
1 Readiness of mould for production.
2 Recording of feedback/concern from mould during the production run.
3 Correction of mould in time (after each production lot).

Mould Change Plan: Mould setter check


the mould change plan for any loading -
unloading of mould.

Mould Readiness Check: Mould


setter check the mould readiness
before minimum two hours of
First Shot: Mould setter will take loading as per check sheet.
the first shot after the mould (Repaire the mould if any concern
locking. observed).

Mould Locking: Mould setter will Raw Material: Mould setter


take the locking after checking the verify the raw material, if the raw
ejector movement. material is change then, mould
setter will slide the hopper and
clean the barrle.

Mould Ejector Movement: Mould Mould Loading: Mould setter load


setter check the movement of the mould & check as per check
ejector and sliders. sheet.

Mould Clean: Mould setter will clean the


mould with mould cleaning spray after
loading the mould.

Note: Mould Loader will take the feedback from machine operator for any concern observed during production run
before unloading the mould.
Prepared By: Approved By:

You might also like