Scribd
Upload
301 views1 page

Figure 4.19-Fillet Weld Soundness Tests For WPS Qualification (See 4.11.2)

The document provides requirements for fillet weld soundness tests for weld procedure specification (WPS) qualification. It includes a table specifying the minimum throat thickness (T1 and T2) for various weld sizes used in qualification tests. It also shows a diagram illustrating how to prepare macroetch test specimens for fillet welds, with notes on using the actual maximum plate thickness used in production if it is less than the values in the table.

Uploaded by

Ibrahim shaik
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
301 views1 page

Figure 4.19-Fillet Weld Soundness Tests For WPS Qualification (See 4.11.2)

The document provides requirements for fillet weld soundness tests for weld procedure specification (WPS) qualification. It includes a table specifying the minimum throat thickness (T1 and T2) for various weld sizes used in qualification tests. It also shows a diagram illustrating how to prepare macroetch test specimens for fillet welds, with notes on using the actual maximum plate thickness used in production if it is less than the values in the table.

Uploaded by

Ibrahim shaik
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

AWS 01.

1 :2000 QUALIFICATION

6 in. (150 mm) MIN

y W 2 = MINIMUM MULTIPLE
PASS FILLET WELD
USED IN
Wl = MAXIMUM SINGLE
PASS FILLET WELD
USED IN
CONSTRUCTION CONSTRUCTION

MACROETCH TEST
SPECIMEN

INCHES MILLIMETERS
Weld Weld
Size T1 min* T2 min* Size T1 min* T2 min*
3/16 1/2 3/16 5 12 5
1/4 3/4 1/4 6 20 6
5/16 5/16 8 25 8
3/8 3/8 10 25 10
1/2 1/2 12 25 12
5/8 5/8 16 25 16
3/4 3/4 20 25 20
> 3/4 > 20 25 25

*Note: Where the maximum plate thickness used in production is less than the value shown in the table, the
maximum thickness of the production pieces may be substituted for T1 and T2.

Figure 4.19-Fillet Weld Soundness Tests for WPS Qualification (see 4.11.2)

130

You might also like