Scribd
Upload
321 views1 page

Won't Boot After Replacing CPUA On TAC32 - Elevator Forum

The document discusses troubleshooting issues with a TAC32 controller that will not boot after replacing the CPUA board. It provides suggestions to load the job file and generic software file in specific folders and try resetting and uploading to resolve the black screen issue.

Uploaded by

joselioner
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
321 views1 page

Won't Boot After Replacing CPUA On TAC32 - Elevator Forum

The document discusses troubleshooting issues with a TAC32 controller that will not boot after replacing the CPUA board. It provides suggestions to load the job file and generic software file in specific folders and try resetting and uploading to resolve the black screen issue.

Uploaded by

joselioner
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

16/9/21 10:58 Won't boot after replacing CPUA on TAC32 - Elevator Forum

Home
 Forums  Technical Questions  Won't boot after replacing CPUA on TAC32 You are not logged in. [Log In]
Register
Forums
Calendar
Active Threads
Forum Help

 Previous Thread Next Thread 


Print Thread

Won't boot after replacing CPUA on TAC32
  #29903 - 09/11/20 01:50 PM

Elevator_Logic
 

I just replaced a CPUA board on a Tac 32 Hydo. Now the LCD display is just black blocks. When I
Elevator_Logic

attempt to use the USB to upload the job file the STAT led keeps blinking rapidly

Joined: May 2019

Posts: 28

USA


Re: Won't boot after replacing CPUA on TAC32
[Re: Elevator_Logic]
  #29904 - 09/11/20 03:26 PM

wltr00
 

You need to have the job file in a folder named update in a folder named tke. Once you have that,
member

press and hold reset and while holding reset press and hold udl. Let off the reset while holding udl.
After a few seconds the stat light should blink slow, slow, fast, fast. Once that happens let go off
Joined: May 2015

udl and software should load. Controller will reset when finished.
Posts: 169


Re: Won't boot after replacing CPUA on TAC32
[Re: Elevator_Logic]
  #29905 - 09/11/20 05:16 PM

Indirtwetrust
 

You also need a generic software file in the update folder if the board has never had one loaded
ElevatorPractitioner

Joined: Dec 2015

Posts: 1,154

Local 18

Hop To
  Technical Questions
ubbthreads stock

show/hide columns on this page

Forum Rules ·
Mark All Read Contact Us: [email protected]
·
Home
·
Top

Powered by UBB.threads™ PHP Forum Software 7.6.0

Page Time: 0.037s Queries: 16 (0.018s) Memory: 2.6635 MB (Peak: 2.8068 MB) Zlib disabled. Server Time: 2021-09-16 14:57:50 UTC

www.vatortrader.com/forums/ubbthreads.php?ubb=showflat&Number=29904 1/1

You might also like