Scribd
Upload
401 views1 page

Quiz 4

The document contains 22 multiple choice questions from past Philippine electrical engineering board exams. The questions cover topics such as determining power factor angle in an RLC series circuit, calculating inductance value based on impedance measurements at different frequencies, and calculating power absorbed and percentage overcurrent for coils connected to different voltage and frequency sources.

Uploaded by

dummy
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as TXT, PDF, TXT or read online on Scribd
401 views1 page

Quiz 4

The document contains 22 multiple choice questions from past Philippine electrical engineering board exams. The questions cover topics such as determining power factor angle in an RLC series circuit, calculating inductance value based on impedance measurements at different frequencies, and calculating power absorbed and percentage overcurrent for coils connected to different voltage and frequency sources.

Uploaded by

dummy
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as TXT, PDF, TXT or read online on Scribd
You are on page 1/ 1

16.

REE Board Exam April 1997


Determine the power factor angle in the series circuit
which consists of R = 25 O, L = 0.2 H, across a power
supply of 200 V, 30 Hz.
A. 36.4� C. 52.4�
B. 46.4� D. 56.4�

17. EE Board Exam April 1993


The impedance coils absorbs 250 watts when
connected across 220 V, 60 Hz mains. It is then
connected across 110 V, 25 Hz mains and also
absorbs 250 watts. What is the inductance of the coil?
A. 0.125 H C. 0.154 H
B. 0.149 H D. 0.163 H
18. REE Board Exam September 2001
In laboratory experiment, the impedance of the coil
was obtained at 60 Hz and 30 Hz. These are 75.48
ohms and 57.44 ohms respectively. What is the
inductance of the coil?
A. 150 mH C. 42.5 mH
B. 182.5 mH D. 2.1 mH

19. REE Board Exam September 2002


A 10 ohms inductive resistor is connected in series
with an unknown capacitance. At 60 Hz the
impedance of the circuit is 10 + j11.72 ohms. At 30 Hz
the impedance of the circuit is 10 � j5 ohms. What is
the value of L in millihenrys?
A. 50 C. 100
B. 500 D. 250

20. REE Board Exam April 1995


An impedance coil takes 10 A and absorbs 250 W
when connected across a 220 V, 60 Hz source. What
power will it absorb when connected across 110 V, 25
Hz mains?
A. 539 W C. 439 W
B. 239 W D. 339 W

21. EE Board Exam October 1984


An industrial coil has a resistance of 32 ohms and a
reactance of 24 ohms and rated 440 volts at 60 Hz. A
factory will connect the coil to a 440 V, 50 Hz supply.
How much percentage over-current will the coil
suffer?
A. 5% C. 6%
B. 10% D. 8%

22. REE Board Exam March 1998


A 25 O resistor connected in series with a coil of 50 O
resistance and 150 mH inductance. What is the power
factor of the circuit?
A. 85% C. 90%
B. 80% D. 75%

You might also like