0% found this document useful (0 votes)
203 views2 pages

5410MKII

The ARG 5410 MkII EPIRB Test Set allows users to check the correct operation of distress beacons that use COSPAS/SARSAT satellites, including EPIRBs, ELTs, and PLBs. It can receive and decode signals directly from beacons or through its own antenna. Test results are displayed on the LCD screen and stored for downloading. The unit meets international standards for annual testing of emergency beacons.

Uploaded by

sathish kumar
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
0% found this document useful (0 votes)
203 views2 pages

5410MKII

The ARG 5410 MkII EPIRB Test Set allows users to check the correct operation of distress beacons that use COSPAS/SARSAT satellites, including EPIRBs, ELTs, and PLBs. It can receive and decode signals directly from beacons or through its own antenna. Test results are displayed on the LCD screen and stored for downloading. The unit meets international standards for annual testing of emergency beacons.

Uploaded by

sathish kumar
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 2

EPIRB Test Set ARG5410 MKII

Check the correct operation of EPIRB, ELT and PLB distress beacons
COSPAS/SARSAT.

The ARG 5410 MkII EPIRB Test Set provides accurate, independent checks of the correct
operation of COSPAS/SARSAT distress beacons, such as EPIRB, ELT and PLB.

It can be connected directly through a suitable attenuator, or will receive the radiated signal using
it's own antenna. Radiated tests should be carried out using the beacons own self-test mode, if
provided, or a screened room or enclosure.

The unit comes complete with user friendly software, designed to guide the operator through the
test procedures, with received signals decoded into plain English.

Messages are time-tagged and stored, and can be viewed on the internal LCD display.
Alternatively, by using the serial data output, data can be downloaded to a printer or PC.

 Receives and decodes all types of COSPAS and SARSAT  Indication of 121 and 406 MHz power measurement.
beacon signals.

 Audible indication of 121.5MHz operation.  Large backlit LCD screen.

 Radiated signal or 50 ohms direct input option.


 Re-chargeable battery and mains charger
 Serial data output to printer or PC. Independent check
of serial number and call sign.
 Integral serial output

 Measures 406MHz carrier frequency.


 Splash proof carrying case

 Easily updateable software/database of country codes

 ‘Long message’ and location protocols included

Tel +44 (0)1285 658501 Fax +44 (0)1285 885376 Email [email protected] www.arg.co.uk

A•R•G ElectroDesign Ltd • Querns Business Centre • Whitworth Road • Cirencester • Glos • GL7 1RT
ARG5410 MkII meets and exceeds the
Typical Message
following IMO requirements for test
equipment for annual testing and shore- **** ARG5410 BEACON TESTER ****
based maintenance of EPIRBS: ***** 11:51:27 28 May 2004 ****
• SOLAS Chapter IV, paragraph 15.9 MESSAGE No.2

• MSC Circular 1039 RECEIVED AT: 18:02:09 17 May 2007


FRAMING/STATUS: NORMAL OK
• MSC Circular 1040
FREQUENCY: 406.0278 MHz PASS
• New version of industry standard tester
COUNTRY: 366 USA
• Works with all beacons - radiated or 50ohm 30 HEX ID: 96EF6CAF893B7A0
connection
2C39BB70908014B
• Fully decodes all message protocols
15 HEX ID: 2DDED95F1276F40
• Measures power and frequency at 406MHz
PROTOCOL: NAT LOC
• Measures power and gives audible BEACON TYPE: TEST +Int GPS
indication of 121.5MHz homing signal
IDENTITY: Ser # 111294
• Stores and time tags 30 messages
HOMING: 121.5MHz
• Integral rechargeable battery OTHER INFO:
• Integral serial output to PC or printer 406MHz Power 102

• Flash programmable memory allows easy 121.5MHz Power 48


user upgrades (free downloads from this
website)
Long Mesg OK
• Optional PC software creates message
database and prints test certificates for Pos 36 57 44 N 122 0 8 W
IMO annual maintenance and shore-based
maintenance (MSC Circ. 1039/1040) ***********************************
****

Tel +44 (0)1285 658501 Fax +44 (0)1285 885376 Email [email protected] www.arg.co.uk

A•R•G ElectroDesign Ltd • Querns Business Centre • Whitworth Road • Cirencester • Glos • GL7 1RT

You might also like