Motokicks Hover Shoes. A Guide For Your Ride.: Model: Jmoto-Blk
Motokicks Hover Shoes. A Guide For Your Ride.: Model: Jmoto-Blk
Motokicks Hover Shoes. A Guide For Your Ride.: Model: Jmoto-Blk
Hover Shoes.
A guide for
your ride.
Model: JMOTO-BLK
Remember to be
safe and
most importantly,
have fun!
What’s in the Box
1. Power Button 6. Wheel
2. Mat Sensor 7. Connector Attachment
3. Carrying Handle 8. Charger
4. LED Lights 9. Charging Cable
5. Charging Port
(On opposite side)
1.
4.
2.
5.
3.
6.
8.
7.
9.
- Charging
- Charge Complete
Light
Warning: The MotoKicks will automatically turn off once the battery
power goes below 10% as a safety precaution.
How to Recalibrate
Hold for
5 seconds
1. Turn the MotoKicks off and place them on a flat, level surface.
2. Hold each Power Button (for about 5 seconds) until the lights
flash and the MotoKicks beep.
3. Restart the MotoKicks by turning them off and then on.
2. Make Moves
1.Power On
Place on level ground, then
turn on each MotoKicks.
2.Balance Mode
Gently tilt each MotoKicks
and they will self-stabilize.
3.Get Going!
Step on one at a time and
get ready to ride!
Please Note: Images may not reflect exact appearance of actual product.
Connector Attachment
CLEANING
To clean the MotoKicks, first make sure they are turned off and
the Charging Ports are covered. Carefully wipe with a damp cloth,
then dry with a dry cloth. Do not use water to clean the
MotoKicks, as the electrical and electronic systems may get wet,
resulting in personal injury or malfunction of the MotoKicks.
BATTERY
• Keep away from fire and excessive heat.
• Avoid intense physical shock, severe vibration, or impact.
• Protect from water or moisture.
• Do not disassemble the MotoKicks.
• If there are any issues with the battery, please contact
Jetson Customer Support.
STORAGE
• Fully charge each battery before storing. Each battery should
be fully charged once a month after this.
• To protect against dust, cover the MotoKicks.
• Store the MotoKicks indoors, in a dry place and at a suitable
temperature for charging.
California Proposition 65
WARNING:
This product can expose you to a chemical such as Chromium that is known to
the state of California to cause cancer or birth defects or other reproductive harm.
For more information go to www.p65warnings.ca.gov/product
NOTICE OF COMPLIANCE
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
Warning: Changes or modifications to this unit not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
• Consult the dealer or an experienced radio/ TV technician for help.
Shielded cables must be used with this unit to ensure compliance with the Class B FCC limits.
Enjoying the ride?
Leave a review on ridejetson.com/reviews or share your photos with us
online using the #RideJetson hashtag!
www.ridejetson.com
Follow us @ridejetson
#MakeMoves