Scribd Logo
Upload

Welcome to Scribd!

  • 158 views

    Cylinder Head Installation On Caterpillar 3054C Diesel Engines

    Uploaded by

    Priscila Cambronero

    Copyright:

    © All Rights Reserved
    Download as PDF, TXT or read online from Scribd

    Cylinder Head Installation On Caterpillar 3054C Diesel Engines

    Uploaded by

    Priscila Cambronero
    158 views2 pages

    Original Title

    TB082316-1

    Copyright

    © © All Rights Reserved

    Available Formats

    PDF, TXT or read online from Scribd

    Did you find this document useful?

    Is this content inappropriate?

    Copyright:

    © All Rights Reserved
    Download as PDF, TXT or read online from Scribd
    Download as pdf or txt
    158 views2 pages

    Cylinder Head Installation On Caterpillar 3054C Diesel Engines

    Uploaded by

    Priscila Cambronero

    Copyright:

    © All Rights Reserved
    Download as PDF, TXT or read online from Scribd
    Download as pdf or txt
    of 2

    Cylinder Head Installation on Caterpillar 3054C

    Diesel Engines
    The AERA Technical Committee offers the following information on cylinder head installation for
    Caterpillar 3054C diesel engines. This information is somewhat unique to this engine series and differs
    from previous 3054 series engines.

    The torque sequence and procedures shown below should be followed after the cylinder head has
    been resurfaced or deemed acceptable using the specification listed below.

    Cylinder Head Specifications

    Dimension Maximum Permissible Distortion


    Width (A) .0018” (.033 MM)
    Height (B) .0019” (.050 MM)
    Diagonal Line(C) .0019” (.050 MM)
    Width (D) .0018” (.033 MM)

    Cylinder Heat Thickness New 4.643-4.647” (117.950-118.050 MM)


    Cylinder Head Thickness Minimum 4.614” (117.200 MM)

    Page 1 of 2

    This information is provided from the best available sources. However, AERA does not assume responsibility for data accuracy or
    consequences of its application. Members and others are not authorized to reproduce or distribute this material in any form, or issue it to their
    branches, divisions, or subsidiaries, etc. at a different location, without written permission.

    © AERA Engine Builders Association. All rights reserved.


    Cylinder Head Installation

    Before installation, lubricate the threads and the underside of the head bolts with clean engine oil.
    There are seven longer (1, 3 & 4) and three shorter (2, and 5-10) bolts used.
    1. Tighten all bolts in the sequence that is shown in Figure 2 to 37 FT/LBS (50 Nm)
    2. Tighten all bolts again in sequence to 74 FT/LBS (100 Nm)
    3. Tighten the seven short bolts (2 and 5-10) an additional 225° (5/8 of a turn)
    4. Tighten the three long bolts(1, 3 & 4) for the additional 270° (3/4 of a turn)

    Figure 2. Head Bolt Torque Sequence Figure 3. Degree Torques

    Page 2 of 2

    This information is provided from the best available sources. However, AERA does not assume responsibility for data accuracy or
    consequences of its application. Members and others are not authorized to reproduce or distribute this material in any form, or issue it to their
    branches, divisions, or subsidiaries, etc. at a different location, without written permission.

    © AERA Engine Builders Association. All rights reserved.

    You might also like