Scribd
Upload
257 views1 page

Experiment-3 - Mesh Analysis Method

This document describes an experiment to determine unknown branch currents in a DC circuit using mesh analysis and verify the results. The circuit diagram shows a DC power supply connected to three resistors. Experimental data was collected by measuring the voltage across each component and calculating the branch currents using mesh equations. The calculated currents were then compared to those measured directly using a multimeter to verify the results.

Uploaded by

Mahomuda Akter
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOC, PDF, TXT or read online on Scribd
257 views1 page

Experiment-3 - Mesh Analysis Method

This document describes an experiment to determine unknown branch currents in a DC circuit using mesh analysis and verify the results. The circuit diagram shows a DC power supply connected to three resistors. Experimental data was collected by measuring the voltage across each component and calculating the branch currents using mesh equations. The calculated currents were then compared to those measured directly using a multimeter to verify the results.

Uploaded by

Mahomuda Akter
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOC, PDF, TXT or read online on Scribd
You are on page 1/ 1

(Established in 1991.

Approved by the Government of Bangladesh)


Founder: Prof Dr M Alimullah Miyan
NAME: -
ID No: -
Group No: -
Program: Date: 15/02 /2021
1. EXPERIMRNT NO: -03
2. Name of the Experiment: - Determination of unknown branch current of an D.C. circuit and verify it by Mesh analysis
method.
3. CIRCUIT DIAGRAM: -

4. EQUIPMENTS REQUIRED: -
a) Fixed &Variable D.C. power supply h)
b) Resistor. R1= 250 Ω, R2= 350 Ω, R3= 450 Ω. i)
c) Multimeter j)
d) Connecting wire k)
f) Project Board l)
g) m)

5. EXPERIMENTAL DATA: -

Mesh Branch currents Branch currents


From Mesh-1 currents (Calculated) (Measured)
V1 V2 From Mesh-2 (mA) (A)
(mA)
Sl (Volt) (Volt) i2R2+ V2+R3(i2-i1)=0 i1 i2 I3 =
-V1+i1R1+R3(i1-i2)=0 I1 I2 I1 I2 I3
no i1-i2

-20+250i1+450(i1-i2) =0 350i2+15+450(i2-i1) =0
25.80

30.1

25.9

30.1
-4.19

-4.2
25.9

-4.2

1 20 15 =>700i1-450i2=20 =>-450i1+800i2=-15
=>35i1-22.5i2=1 =>-45i1+80i2=-1.5

350i2+22+700(i2-i1) =0
-40+250i1+450(i1-i2) =0
=>35i2+2.2+70(i2-i1) =0
61.8

7.27

54.5

2 40 22 =>4-25i1-45(i1-i2) =0

6. MATHMATICAL CALCULATION (While writing report): -

7. RESULTS: -

Instructor: Md, Turiqul Islam

You might also like