Scribd
Upload
43 views

Work Instruction No.: 6.4 Modify SCTN: Sctnform Restform

Uploaded by

Skr9143 Shiv
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
43 views

Work Instruction No.: 6.4 Modify SCTN: Sctnform Restform

Uploaded by

Skr9143 Shiv
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

Work Instruction No.

: Page 22 of 25

6.4 Modify sctn


[Pipesupport shortcut menu > Pipesupport Bar > Modify > Modify Sctn]

Modify profile type from the pull down menu (Remember to run SctnForm to set materials).
Flip Bangle turns the SCTN by it’s LTS in 90 degrees increments.
Extend Sctn allows you to stretch or shorten a SCTN by identifying PLINE on any other
SCTN (Remember to run RestForm to calculate new cog & weight)

6.5 Modify support name


[Pipesupport shortcut menu > Pipesupport Bar > Modify > Modify Support name]

Navigate to REST and enter new name. This will change REST and FRMW names along with
references.

6.6 Modify trunnion


[Pipesupport shortcut menu > Pipesupport Bar > Modify > Modify trunnion]

Navigate to trunnion (BRAN). Modify Size and length.

To reselect pipe spec for trunnion go to [RestForm


shortcut menu > Restform > Trunnion > Change
Spec ]

You might also like