Scribd
Upload
1K views1 page

Roundness Check Record of 1St Shell Course

This document is a roundness check record for the first shell course of a tank. It summarizes the measurements taken at different points around the shell to check that the radius is within the allowed tolerances. The measurements show that at check points ranging from 0 to 3150, the actual radius was within 6-7mm of the required 10992.5mm radius, which is within the tolerances allowed. The record documents the inspection process to confirm that the first shell ring meets roundness specifications.

Uploaded by

Rhannie Garcia
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as XLSX, PDF, TXT or read online on Scribd
1K views1 page

Roundness Check Record of 1St Shell Course

This document is a roundness check record for the first shell course of a tank. It summarizes the measurements taken at different points around the shell to check that the radius is within the allowed tolerances. The measurements show that at check points ranging from 0 to 3150, the actual radius was within 6-7mm of the required 10992.5mm radius, which is within the tolerances allowed. The record documents the inspection process to confirm that the first shell ring meets roundness specifications.

Uploaded by

Rhannie Garcia
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as XLSX, PDF, TXT or read online on Scribd
You are on page 1/ 1

Form No.

RC

ROUNDNESS CHECK RECORD OF 1ST SHELL COURSE

Client : EPC/FBI Date : 16-Feb-15


Project Tittle : San Gabriel Avion 97-115MW OCGT Report No. : BST-FB-RC-001
Tank No. : CO.08.1 Procedure and Rev. No. : _________________
DWG. and Rev. No. : 81.301, Rev.3

Actual Shell Actual


Check Shell Diff. Check Diff.
Radius Rem arks Plate Dadius Rem arks
Point Plate No. (mm)
(m m) Point (mm)
(m m)
No.
0⁰ Shell Plate #5 10994.5 2 Acc
45⁰ Shell Plate #3 10998.5 6 Acc
90⁰ Shell Plate #2 10995.5 3 Acc
135⁰ Shell Plate #13 10998.5 6 Acc
180⁰ Shell Plate #11 10997.5 5 Acc
225⁰ Shell Plate #10 10998.5 6 Acc
270⁰ Shell Plate #8 10998.5 6 Acc
315⁰ Shell Plate #6 10999.5 7 Acc

* Note : 1) Tank inside diameter : 10992.5 mm


1st shell ring
2) Measurement shall be made after verts
and comer welds are completely weld. Inside
radius
3) Roundness tolerances.
Diameter (mm) Radius Tolerance (mm) 300 mm
< 12, 192 + 12.7
G.L.
12,192 to < 45,720 + 19.1
45,720 to < 76,200 + 25.4
Bottom PL
> 76,200 + 31.8
4) The measurement point is at the middle on each plate from 0˚clock wise.

Prepared by Witnessed / Reviewed by Witnessed / Reviewed by

_____________________ ______________________ _____________________


BSTECH FBI EPC
Date : _______________ Date : ________________ Date : _______________

Form No. RC

You might also like