Scribd
Upload
3K views1 page

Stress Relieving Procedure

The document outlines a 5-step stress relieving procedure for a component: 1) Load the component into a furnace below 100°C, 2) Heat it to 600±20°C over 50-80°C per hour, 3) Soak it at that temperature for 2-2.5 hours, 4) Cool the furnace to 150-200°C over 50-60°C per hour, then 5) Remove and further cool the component to room temperature.

Uploaded by

Corrosion Factory
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
3K views1 page

Stress Relieving Procedure

The document outlines a 5-step stress relieving procedure for a component: 1) Load the component into a furnace below 100°C, 2) Heat it to 600±20°C over 50-80°C per hour, 3) Soak it at that temperature for 2-2.5 hours, 4) Cool the furnace to 150-200°C over 50-60°C per hour, then 5) Remove and further cool the component to room temperature.

Uploaded by

Corrosion Factory
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 1

STRESS RELIEVING PROCEDURE

1. Load A Component Into The Furnace When The Temperature Of Furnace Is At 100
Degree Centigrade Or Lower.

2. Heat The Component Up To 600+/- 20 Degrees Centigrade @50-80 Degree Centigrade


Per Hour.

3. Hold The Component (Soaking) At 600+/- 20 Degree Centigrade Between 2 Hours To


2 ½ Hours.

4. Furnace Cooling Up to 150-200 Degree Centigrade @50-60 Degree Centigrade per


Hour.

5. Remove It From The Furnace And Cool Further To Room Temperature & Stress
Relieving IS-16355-1993 Wherever Welding Done.

SOFTEC SERVICES

DATE: 09-03-2020 DC NO. - 098

Complete Aircraft Hoisting Sling, Stress. – 08 Nos.


Drawing No- 121E94.160.00 M1 F1

Mythri Metallizing Pvt Ltd

Authorised Signature

You might also like