556H Honda/Acura Immobilizer

Bypass Module

After completing all remote start wiring connections, insert the

Models
vehicle key into the ignition switch. Do NOT turn the ignition on.
Mode 1 Mode 2
■ Honda Accord 2003-2004 ■ Honda Accord 1998-2002 Activate the remote start.
■ Honda CRV 2002-2004 ■ Honda CRV 1998-2001
If the vehicle remote starts, proceed with the 556H installation.
■ Honda Civic 2001-2004 ■ Honda Odyssey 1998-2003
■ Honda Element 2003-2004 ■ Honda Pilot 2003 If the vehicle fails to start, check all ignition and tachometer con-
■ Acura RSX 2002-2004 ■ Acura CL 1998-2003 nections and retest. Do NOT proceed with 556H installation until
■ Acura TSX 2004 ■ Acura Integra 2000-2002 this test is successful.
■ Acura TL 2004 ■ Acura MDX 2001-2002
■ Acura MDX 2003 ■ Acura TL 1998-2002 A successful test verifies that all ignition and tachometer con-
■ Acura 1.7EL 2001-2004 ■ Acura 1.6EL 1998-2000 nections are correct. This will eliminate the remote start as the

Product Description cause of a failure to start after completing the 556H installation.

The Honda/Acura Immobilizer anti-theft system uses a low-power

Installation Instructions
transponder mounted in the head of the ignition key. When the
1. Remove steering column shroud to gain access to the wire har-
vehicle is started, the Key Cylinder Module converts the transpon-
nesses at the rear of the ignition switch.
der signal and sends a secure, coded signal to the Engine Control
2. Locate the appropriate wires exiting the ignition switch and
Module. If the signal to the Engine Control Module is correct, the immobilizer receiver. The wire colors are listed in the Wire
vehicle will start. Color Guide.
3. Wire the 556H as shown in the wiring diagram.
The 556H uses a unique auto-program sequence to learn the secure

code from the Key Cylinder Module and repeats it when remote start Wire Color Guide
is activated, eliminating the need to leave a key in the vehicle. GROUND BLACK
(+) 12V BATTERY RED
The 556H Honda/Acura Immobilizer Bypass Module integrates into IGNITION IN PINK
the wiring for the Honda/Acura immobilizer anti-theft system to IGNITION OUT PINK/BLACK
allow remote start capability, while still allowing normal function DATA YELLOW/BLACK

of the factory immobilizer anti-theft system. DATA YELLOW

N.C. ORANGE
WARNING! It is recommended that the 556H Immobilizer DATA 2 IN ORANGE/BLACK
Bypass Module only be installed by an authorized
Directed dealer. Attempting installation without the (-)GROUND IN BLUE/WHITE
proper tools and training can result in damage to the (-)NEGATIVE GREEN
vehicle electronics.

Wire Connection Guide

Pre-Installation Test
■ BLUE/WHITE: Connect this wire to the (-) key sense wire at the
IMPORTANT! Wire connections from the 555H to the ignition cylinder. The key sense wire rests at ground when the
Honda/Acura immobilizer wires should be done AFTER
all remote start connections are completed and the fol- key is inserted into the ignition switch.
lowing test is successful.

© 2004 Directed Electronics, Inc. Vista, CA 1

N556H 10/04
■ BLACK: Connect this wire to a quality chassis ground (prefer- 2. Release the programming button once the LED illuminates.
ably scraped sheet metal) separate from other component 3. Turn the ignition to the On position.
ground locations. 4. Ensure that the module is in the correct mode by counting the
■ RED: Connect this wire to a constant (+)12 volt source. LED flashes (i.e. 1 flash = mode 1).
■ PINK: Connect this wire to the Ignition output from the ECM. 5. Press the program button to switch between modes 1 and 2.
■ PINK/WHITE: Connect this wire to the Ignition input from the 6. Once the mode is selected, turn the ignition Off.
ignition switch. 7. Turn the ignition back On and the LED will illuminate con-
■ YELLOW/BLACK: For mode 1 Connect this wire to data wire that firming that the module has been programmed.
connects from the ECM to the Ignition switch, for mode 2 8. Turn the Ignition Off, remove the key and initiate the remote
connect this wire to the Data wire from the Ignition switch. start sequence.
■ YELLOW: Connect this wire to the same data wire listed above for
mode 1, for mode 2 connect this wire to the Data wire from the NOTE: You must use the BLACK master key to complete the pro-
ECM. gramming procedure.
■ ORANGE: Not Connected
■ ORANGE/BLACK: Not Connected for mode 1, for mode 2 this wire Troubleshooting
is connected to the Data 2 wire that connects the Ignition
With Ignition On
switch and the ECM.
1. LED flashing rapidly = module programmed, but not activated
■ BLUE: Connect this wire to the remote starter.
by input.
■ GREEN: Connect this wire to the ignition switch. 2. LED On (constant) = module not programmed.
With Remote Start
Programming Instructions 1. LED On (constant) = activated by remote start in mode 1.
1. Depress the programming button while inserting the wire 2. LED Off = activated by remote start in mode 2.
harness into the connector.

Mode 1 Wiring Diagram

7 PIN CONN. HONDA

ECM
IGNITION 1 2 3 4 5 6 7
BARREL DATA

PROGRAMMING IGNITION
BUTTON CUT

GREEN (-)NEGATIVE
BLUE/WHITE (-)GROUND IN
ORANGE/BLACK N.C.
556H

ORANGE N.C.
YELLOW DATA
YELLOW/BLACK DATA
PINK/BLACK IGNITION OUT
PINK IGNITION IN
RED (+)12V BATTERY
BLACK (-) GROUND
REMOTE
STARTER

2 © 2004 Directed Electronics, Inc. Vista, CA

N556H 10/04
 VEHICLE (Mode 1)

MAKE MODEL YEAR

HONDA CIVIC 2001-2004
CRV 2002-2004
ACCORD 2003-2004
ELEMENT 2003-2004
ACURA 1.7EL 2001-2004
RSX 2002-2004
TSX 2004
TL 2004
MDX 2003
WIRE COLOR
Civic CRV Accord
Pin# MDX TL
1.7EL Element TSX
Brown/Yellow (negative) 1 X X X X X
Red/Blue (data) 2 X X X
Red (data) 2 X
White (data) 2 X
Yellow/Black (ignition) 6 X X
Black/Yellow (ignition) 6 X
Green/White (ignition) 6 X
Black (ignition) 6 X

Mode 2 Wiring Diagram

7 PIN CONN. HONDA

ECM
IGNITION 1 2 3 4 5 6 7
BARREL DATA

PROGRAMMING IGNITION
BUTTON CUT

GREEN (-)NEGATIVE
BLUE/WHITE (-)GROUND IN
ORANGE/BLACK N.C.
556H

ORANGE N.C.
YELLOW DATA
YELLOW/BLACK DATA
PINK/BLACK IGNITION OUT
PINK IGNITION IN
RED (+)12V BATTERY
BLACK (-) GROUND
REMOTE
STARTER

© 2004 Directed Electronics, Inc. Vista, CA 3

N556H 10/04
 VEHICLE (Mode 2)

MAKE MODEL YEAR

HONDA ODYSSEY 1999-2003
CRV 1998-2001
ACCORD 1998-2002
PILOT 2003
ACURA 1.6EL 1998-2001
INTEGRA 2000-2004
CL 1998-2003
TL 1998-2003
MDX 2001-2002
WIRE COLOR
Odyssey Accord
Pilot
MDX CL & TL
Brown/Black (negative) X X
Brown/Yellow ( negative) X X
Blue/Green (data 1) X
Red (data 1) X X
Orange/Blue (data 2) X
Blue (data 2) X
Yellow/Black (ignition) X X X

4 © 2004 Directed Electronics, Inc. Vista, CA

N556H 10/04