Bills of Quantities (Boq) : Construction of Rear Side Boundary Wall at SRCC

Download as pdf or txt
Download as pdf or txt
You are on page 1of 3

BILLS OF QUANTITIES (BOQ)

CONSTRUCTION OF REAR SIDE BOUNDARY WALL AT SRCC


DSR NO. DESCRIPTION OF ITEM/DSR SUB. NO. QTY. RATE PER AMOUNT

EARTH WORK :
2.6 Earth work in excavation by mechanical means
(Hydraulic excavator) / manual means over areas
(exceeding 30cm in depth. 1.5m in width as well
as 10 sqm on plan) including disposal of
excavated earth, lead upto 50m and lift upto 1.5m,
disposed earth to be levelled and neatly dressed.

2.6.1 All kinds of soil 100 Cum.


2.25 Filling available excavated earth (excluding rock)
in trenches, plinth, sides of foundations etc. in
layers not exceeding 20cm in depth, consolidating
80 Cum.
each deposited layer by ramming and watering,
lead up to 50 m and lift upto 1.5 m.

PLAIN CEMENT CONCRETE WORK :

4.1 Providing and laying in position cement concrete


of specified grade excluding the cost of centring &
shuttering all work upto plinth lvl.
4.1.8 1:4:8 (1 cement: 4 coarse sand: 8 graded stone
aggregate 40mm nominal size). 17.25 Cum.

REINFORCED CEMENT CONCRETE


WORK :
5.2 Reinforced cement concrete work in wall (any
thickness) including attached pilasters,buttresses,
plinth and string courses, fillets, columns, pillars,
piers, abutments, posts and struts etc. up to floor
fivelevel excluding cost of centering, shuttering,
finishing and reinforcement:

5.2.2 1:1.5:3 (1 cement :1.5 coarse sand : 3 graded


stone aggregate 20 mm. nominal size). 85 Cum.

5.9 Centring and shuttering including strutting ,


propping etc. and removal of form work for :

5.9.1 Foundations, footings, bases of columns, etc. for


115 Sqm.
mass concrete
5.9.5 Lintels, beams, plinth beams, girders, bressumers
425 Sqm.
and cantilevers
5.9.6 Columns, Pillars, Piers, Abutments, Posts and
120 Sqm.
Struts
5.22 Reinforcement for R.C.C. work including
straightening, cutting, bending, placing in position
and binding all complete.
5.22.6 Thermo-Mechanically Treated bars. 9350 Kg.

Page 1
DSR NO. DESCRIPTION OF ITEM/DSR SUB. NO. QTY. RATE PER AMOUNT

BRICK WORK

6.4 Brick work with common burnt clay F.P.S. (non


modular) bricks of class designation 7.5 in
superstructure above plinth level up to floor V
level in all shapes and sizes in :
6.4.1 Cement mortar 1:4 (1 cement : 4 coarse sand)
12 Cum.
6.13 Half brick masonry with common burnt clay F.P.S.
(non modular) bricks of class designation 7.5 in
superstructure above plinth level up to floor V
level.
6.13.1 Cement mortar 1:3 (1 cement :3 coarse sand)
350 Sqm.
6.15 Extra for providing and placing in position 2 Nos.
6mm dia. M.S. bars at every third course of half 350 Sqm.
brick masonry.

FINISHING & CLADDING WORK :

13.1 12 mm cement plaster of mix :


13.1.2 1:6 (1 cement: 6 fine sand) 600 Sqm.
13.2 15 mm cement plaster on the rough side of single
or half brick wall of mix :
13.2.2 1:6 (1 cement: 6 fine sand) 600 Sqm.
13.44 Finishing walls with water proofing cement paint
of required shade :
13.44.1 New work (Two or more coats applied @ 3.84
kg/10 sqm). 1200 Cum.

13.65 Painting with black anti-corrosive bitumastic paint


of approved brand and manufacture to give an
even shade:
13.65.1 Two or more coats on new work.
55 Sqm.

Page 2
DSR NO. DESCRIPTION OF ITEM/DSR SUB. NO. QTY. RATE PER AMOUNT

MISCELLANEOUS WORK :
16.11 Dry stone pitching 22.5 cm thick including supply
of stones and preparing surface complete. 400 Sqm.

16.18 Fencing with angle iron post placed at required


distance embedded in cement concrete blocks,
every 15th post, last but one end post and corner
post shall be strutted on both sides and end post
on one side only and provided with horizontal
lines and two diagonals interwoven with horizontal
wires, of barbed wire weighing 9.38 kg per 100 m
(minimum), between the two posts fitted and fixed
with G.I. staples, turn buckles etc. complete. (Cost
of posts, struts, earth work and concrete work to
be paid for separately) :- Payment to be made per
metre cost of total length of barbed wire used.

16.18.1 With G.I. barbed wire 1020 Meter


16.19 Supplying at site Angle iron post & strut of
required size including bottom to be split and bent
at right angle in opposite direction for 10 cm 650 Kg.
length and drilling holes upto 10 mm dia. etc.
complete.

TOTAL

Page 3

You might also like