Scribd
Upload
34 views

Arduino Itm

The document lists components needed for an electronics project including integrated circuits, resistors, capacitors, LEDs, crystals, voltage regulators, switches and other basic electronic parts.

Uploaded by

anshuman singh
Copyright
© © All Rights Reserved
Available Formats
Download as TXT, PDF, TXT or read online on Scribd
34 views

Arduino Itm

The document lists components needed for an electronics project including integrated circuits, resistors, capacitors, LEDs, crystals, voltage regulators, switches and other basic electronic parts.

Uploaded by

anshuman singh
Copyright
© © All Rights Reserved
Available Formats
Download as TXT, PDF, TXT or read online on Scribd
You are on page 1/ 1

1.

IC, ATmega328 bootloader(1)


2. Socket, IC, 28-pin, 0.3"(1)
3. IC, 5V regulator(1)
4. LED, Red (1)
5. LED, Green(1)
6. Resistor, 1/4W, 10K ? (1)
7. Resistor, 1/4W, 180 ?(2)
8. Capacitor, 10�F, 50V(2)
9. Crystal, 16 MHz, low-profile(1)
10. Capacitor, ceramic disc, 22pF, 50V(2)
11. Capacitor, ceramic disc, 0.1�F, 50V(1)
12. Switch, pushbutton, OFF-(ON)(1)
13. Header, 6-pin, 1-row, vertical, 0.1"(1)
14. IC, 3.3V regulator, LM1117T-3.3(1)
15. Capacitor, tantalum, 10�F, 25V(2)
16. Breadboard
17. IR sensor

-perfboard
-two 10 uf electrolytic capacitors
-two 10 uf tantalum capacitors
-7805 voltage regulator (5v)
-LM1117T-3.3 voltage regulator(3.3v)
-green LED
-red LED
-two 150 ohm resistors
-10k resistor
-one 0.1 uf capacitor (ceramic disk)
-two 22 pf capacitors (ceramic disk)
-16 MHz crystal oscillator
-momentary push button switch
-jumper wires
-female headers (I used three rows of eight)
-row of 6 male headers
-female wall wart power jack
-ATmega328 with bootloader
-28 pin DIP IC socket

You might also like