0% found this document useful (0 votes)
20 views3 pages

Arduino Itm

Uploaded by

anshuman singh
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as XLSX, PDF, TXT or read online on Scribd
0% found this document useful (0 votes)
20 views3 pages

Arduino Itm

Uploaded by

anshuman singh
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as XLSX, PDF, TXT or read online on Scribd
You are on page 1/ 3

1.

IC, ATmega328 bootloader(1)


2. Socket, IC, 28-pin, 0.3"(1)
3. IC, 5V regulator(1)
4. LED, Red (1)
5. LED, Green(1)
6. Resistor, 1/4W, 10K Ω (1)
7. Resistor, 1/4W, 180 Ω(2)
8. Capacitor, 10µF, 50V(2)
9. Crystal, 16 MHz, low-profile(1)
10. Capacitor, ceramic disc, 22pF, 50V(2)
11. Capacitor, ceramic disc, 0.1µF, 50V(1)
12. Switch, pushbutton, OFF-(ON)(1)

13. Header, 6-pin, 1-row, vertical, 0.1"(1)


14. IC, 3.3V regulator, LM1117T-3.3(1)
15. Capacitor, tantalum, 10µF, 25V(2)
16. Breadboard

perfboard
-two 10 uf electrolytic capacitors
-two 10 uf tantalum capacitors
-7805 voltage regulator (5v)
-LM1117T-3.3 voltage regulator(3.3v)
green LED
red LED
-two 150 ohm resistors
-10k resistor
-one 0.1 uf capacitor (ceramic disk)
-two 22 pf capacitors (ceramic disk)
-16 MHz crystal oscillator
momentary push button switch
jumper wires
female headers (I used three rows of eight)
row of 6 male headers
female wall wart power jack
ATmega328 with bootloader
-28 pin DIP IC socket
female wall wart power jack
jumper wires
ATmega328 with bootloader
-28 pin DIP IC socket
-7805 voltage regulator (5v)
green LED
red LED
-10k resistor
-two 150 ohm resistors
-two 10 uf electrolytic capacitors -two 10 uf tantalum capacitors
-16 MHz crystal oscillator
-two 22 pf capacitors (ceramic disk)
-one 0.1 uf capacitor (ceramic disk)
momentary push button switch

female headers (I used three rows of eight) row of 6 male headers


-LM1117T-3.3 voltage regulator(3.3v)
A breadboard
22 AWG wire
7805 Voltage regulator
2 LEDs
2 220 Ohm resistors
1 10k Ohm resistor
2 10 uF capacitors
16 MHz clock crystal
2 22 pF capacitors
small momentary normally open
("off") button, i.e. Omron type B3F

You might also like