Norton's Theorem: Ma R R R I I
Norton's Theorem: Ma R R R I I
Norton's Theorem: Ma R R R I I
Norton’s theorem
Description : - To simplify the solutions of the complicated net works, many network
theorems were developed. Norton’s theorem is one of them. The statement of this
theorem is that “ The current ( IL) in a load impedance, connected to two terminals A &
B of a network of generators and linear impedances is same if this load impedance is
connected to a constant current generator, whose generated current ( IN ) is equal to the
short circuit current between the terminals A and B, in parallel with an impedance ( RN )
equal to the impedance of the net work between the same two terminals A and B, when
the generators in the net work have been replaced by their internal impedances.”
Procedure : - The voltage source is disconnected and the terminals are short circuited
by assuming that the internal impedance of the voltage source is zero. And the resistance
across A & B is measured after removing the load RL. This resistance is the Norton’s
resistance RN. Now the voltage source or battery is connected. The current between A &B
is measured. This is the short circuit current and is called as Norton’s current ( IN ). Now
Page 2 of 4
The circuit is replaced by a constant current source IN with a parallel resistor, whose
value is equal to RN. This is the Norton’s equivalent circuit. Now the load RL is also
connected in series with a milli-ammeter between A & B. Then the current IL1 through
the load RL is measured for different values of IN measured in the table-1. The IN and IL1
values are noted in the table-2. It is observed that for same values of IN in tables1 and 2,
the IL and IL1 are equal. Also calculate the IL values using the above formula. These
values are also equal to ILl Values.
Precautions : - 1) To measure IN, the load RL should be removed for each time.
2) The RN computed should be nearly equal to the measured RN value.
Result : - The currents IL and IL1 measured and calculated in tables 1 & 2 are equal for
the same values of IN.
Page 3 of 4
Table-1
Table –2
RN computed = KΩ
RL load resistance = KΩ
Load Load I N RN
IN IL = mA
Current ( Current( IL )
S.No. Computed
IL1) mA R N + RL
mA (Calculated IL)
mA (From table .1)
1.
2.
3.
4.
5.
6.
Page 4 of 4
*****