0% found this document useful (0 votes)
903 views8 pages

Landstar 7 User Manual: Technical Support Engineer Bandwork Gps Solutions S/B

This document provides instructions for using the Landstar 7 GPS software. It outlines how to create a new project, configure Bluetooth connectivity and survey mode, perform site calibration, and export data to CSV, text, and DXF file formats. Steps include selecting a coordinate system, connecting a receiver, choosing RTK network work mode, collecting points, adding GNSS and known points for calibration calculations, and exporting files with specified names and formats.

Uploaded by

yekang
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
0% found this document useful (0 votes)
903 views8 pages

Landstar 7 User Manual: Technical Support Engineer Bandwork Gps Solutions S/B

This document provides instructions for using the Landstar 7 GPS software. It outlines how to create a new project, configure Bluetooth connectivity and survey mode, perform site calibration, and export data to CSV, text, and DXF file formats. Steps include selecting a coordinate system, connecting a receiver, choosing RTK network work mode, collecting points, adding GNSS and known points for calibration calculations, and exporting files with specified names and formats.

Uploaded by

yekang
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 8

2016

LANDSTAR 7 USER MANUAL

Technical Support Engineer


BANDWORK GPS SOLUTIONS S/B.
PROJECT
1. Open Landstar. Go to project and select PRJ MGMT to create job.

2. Select New to create Job. Insert Project Name, for example Test.
3. Select coordinate system. For example GDM2000 Selangor

4. Accept to confirm the coordinate system.


CONFIGURATION
1. Go to Config and select Connect. On receiver and link the bluetooth connection to
controller. The antenna type need to choose same with the type of receiver. For example
CHCX900R.

2. Go to Work Mode. Select MYRTKNET to workmode.


SURVEY

1. Go to Survey and choose Survey Map. Wait until the signal status is Fix to store point .
Insert code to refer data collect.
SITE CALIBRATION
1. Go to Site CAL. Click Add to add GNSS Point(Observation point) and Known Point(reference
point). The method can select Horizontal, Horizontal+Vertical or Vertical. After that, Click on
Calculate to get the result.
EXPORT
1. Go to project, select Export. Choose File Type, for example .csv or .txt.

2. Insert File Name, select the directory to save the file and click Export.
OTHER EXPORT
1. Select Other Export and choose DXF Export for format DXF to open in Autocad. After choose,
click Export. The file save in the job folder.

You might also like