Scribd
Upload
450 views1 page

Basic Electronics Tools and Equipment

The document discusses basic tools used in electronics including a solder station to heat metals for joining, a desoldering tool to remove joints, and solder for joining metals. Other tools mentioned are needle nose pliers for holding small parts, wire strippers for removing insulation from wires, diagonal cutters for cutting wires, a multimeter for testing circuits, a power supply for providing voltage to circuits, and a Dremel drill for making small holes in circuit boards.

Uploaded by

Gultainjee
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
450 views1 page

Basic Electronics Tools and Equipment

The document discusses basic tools used in electronics including a solder station to heat metals for joining, a desoldering tool to remove joints, and solder for joining metals. Other tools mentioned are needle nose pliers for holding small parts, wire strippers for removing insulation from wires, diagonal cutters for cutting wires, a multimeter for testing circuits, a power supply for providing voltage to circuits, and a Dremel drill for making small holes in circuit boards.

Uploaded by

Gultainjee
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

Basic Electronics Tools and Equipment

Solder Station - use to heat up the Desoldering Tool - used to remove Solder - the material that will be
metals that you are going to join solder when a join is to be taken used to join metals together. It has
togther using solder. apart. a low melting point

Needle Nose - mainly used to hold Wire Strippers - as the name Diagonal Cutters - used to cut wires
small wire and parts when your implies, used to strip wire to bare and especially the wires sticking out
figures just can't do it. the conductor. from the bottom of a circuit board
after soldering a part in place

Multimeter - a piece of test Power Supply - used to supply Dremel Drill - used in the shop
equipment used to check that wires power to circuits that you are strickly for drilling small holes in
are not broken, solder joins are working on. It can be varied from 0 circuitboards for parts to be
good, resistance, voltage, etc. volts to 30 volts. soldering into.

You might also like