Scribd
Upload
3K views1 page

DB 15

The document provides information about pinouts for a DB15 connection on a device. It includes a chart describing the pinout for an Alicat-style DB15 connector. The chart lists the pin number and associated function for 15 pins, including pins for power supply, ground, analog signals, and serial communication. It notes that pin assignments may vary by device and to check the specific product documentation.

Uploaded by

Yogesh
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
3K views1 page

DB 15

The document provides information about pinouts for a DB15 connection on a device. It includes a chart describing the pinout for an Alicat-style DB15 connector. The chart lists the pin number and associated function for 15 pins, including pins for power supply, ground, analog signals, and serial communication. It notes that pin assignments may vary by device and to check the specific product documentation.

Uploaded by

Yogesh
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

DB15 Pin-Outs

If your instrument was ordered with a DB15 connection, be sure to check the
Calibration Label on the device and reference the appropriate pin-out diagram.

The following pin-out chart describes the safest and generally compatible arrangement when connecting
a non-Alicat DB15 wire to a DB15 equipped Alicat. Not all features may be available between brands, but
the common denominators are featured in our DB15 offerings, along with some options for customization.

DB15 – Pin-Out Alicat Style


2 5 8
8 5 2

13 15 15 13 11 9
9 11
Male Connector Front View Female Connector Front View
Pin Number Function
1 Ground
2 Primary Analog Signal Output
3 Ground
4 N/C
5 Power Supply (+Vdc)
6 N/C
7 N/C
Analog Tare (meters — when grounded)
8
Analog Set-Point Input (controllers)
9 Power Supply Common
10 Ground
11 Secondary Analog Signal Output / fixed 5.12Vdc
12 N/C
13 RS-232 RX (receive) or RS-485 –
14 Ground
15 RS-232 TX (send) or RS-485 +
Check your device’s calibration certificate and user manual for the actual electrical input/output
requirements, as all instruments are custom configured to some extent.
NOTE: Pins 1, 3, 9, 10 and 14 are connected together inside of the device and are common
grounding points.
N/C = Not Connected/Open (can be used for custom pin assignments – please consult factory).

DOC-DB15PIN Rev7 1 April 12, 2016

You might also like