0% found this document useful (0 votes)
125 views4 pages

Manual

The document provides setup instructions for a portable interactive whiteboard in 4 steps: 1) confirm all components are present, 2) connect the device to a PC via USB and projector via VGA, 3) install the driver software from the included CD, and 4) calibrate the device by clicking points on the projected screen with the e-pen. It also provides notes on usage, recommended projection distances, and answers to common questions.

Uploaded by

shenkee-1
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
0% found this document useful (0 votes)
125 views4 pages

Manual

The document provides setup instructions for a portable interactive whiteboard in 4 steps: 1) confirm all components are present, 2) connect the device to a PC via USB and projector via VGA, 3) install the driver software from the included CD, and 4) calibrate the device by clicking points on the projected screen with the e-pen. It also provides notes on usage, recommended projection distances, and answers to common questions.

Uploaded by

shenkee-1
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 4

Oway Portable Interactive Whiteboard User Guide

For WB2700

Caution: Before Setting Your Portable Interactive Whiteboard, Please Check All the Parts and
Read The User Guide

Step1. Confirm each Step2. Install: The device is Step3. Install Driver: Insert
component connected the PC by USB cable; the CD and Install the
of the Portable IWB is The projector is connected the PC driver, Click “SmartIWB”
present. by VGA Cable icon in the desktop

Step4. Calibrating:
Click the “Calibrate” on the notify menu of SmartIWB, make sure the red laser aim in the middle of the projection area.
Please see below picture.
Click the 15(or 4)points in order, don’t move the e-pen until the point disappeared.
Check the calibration with the e-pen (Look the e-pen and the mouse pointer)
• Working Manner:

• 1. Desktop Install • 2. Projector bundled Install

• Effect: • Note:

The recommended distance from the signal receiver to


projecting screen is 3 – 5m.
Make sure there is no blockage between the signal receiver
and projecting surface before calibrating.
Don’t move the signal receiver after finishing calibration.
Only when the tip of the e-pen is lit can device receive the
signal.
There must not be any blockage between the tip of e-pen and
signal receiver.
Recommended Signal Reception Distance

Projection Size Distance between Receiver and Projection Surface

70 inch 2.1~2.3 m
100 inch 2.9~3.2 m
120 inch 3.5~3.8 m
150 inch 4.4~4.8 m
FAQ:
• Q1. Why mouse can’t move smoothly?
• Add “SmartIWB” to Trusted Zone in the Antivirus Software.
• Or Exit the Antivirus Software.

• Q2. Why the software can’t save setting and calibration?


• Windows 7 64bit & Vista 64bit :
• Close the UAC or Right click SmartIWB and select “Run as Administrator”
• Windows 8:
• Right click SmartIWB and select “Run as Administrator”

You might also like