MCQ (Unit4) - Latest

UNIT-4 MCQ......
SUBJECT:A&P III ECE

1. Which of the following is the most common version of the printed
antenna?
a)Horn
b)Microstrip
c)Wire
d) Lens
2. In which of the following type of antenna a patch is created during

fabrication?
a) Microstrip antenna
b) Horn antenna
c) Wire antenna
d) Lens antenna
3. Microwave frequency range is-------

a) above 30MHZ
b) above 300MHZ
C) above 200MHZ
d) above 2000MHZ.
4). The radiation resistance of folded dipole of equal radii is---------

a) 657Ohms
b) 292 Ohms
C) 300 Ohms
d) 277 Ohms
5). The radiation resistance of folded dipole of unequal

radii(r2=2r1)______
a) 657Ohms
b) 292 Ohms
C) 300 Ohms
d) 277 Ohms
6). If the flare angle of the horn increases, then its beam width ______
a) Decreases
b) Increases
c) Depends on aperture of horn
d) Independent of flare angle
7). The radiation pattern of helix in Axial mode is-----------

a) Bi directional
b) Uni directional
C) 4 lobed
d) Omni directional
8). The radiation pattern of helix in Normal mode is-----------

a) Bi directional
b) Uni directional
C) 4 lobed
d) Omni directional
9. Find the optimum aperture angle for H-plane horn with aperture 12λ
and path travel difference 0.4λ?
a) 75.9°
b) 1.59°
c) 7.59°
d) 15.18°
10. The length of the director compared to the driven element is ______
a) Greater
b) Smaller
c) Independent to each other
d) Depends on the type of driven element
11. For a feeder length of 0.5λ, which among the following would be the
reflector length?
a) 0.525λ
b) 0.425λ
c) 0.23λ
d) 0.35λ
12. For a feeder length of 0.5λ, which among the following would be the
director length?
a) 0.525λ
b) 0.455λ
c) 0.493λ
d) 0.55λ
13. Which of the following statement is not correct?

a) Folded dipole antenna has less impedance than half dipole
b) Folded dipole is a balanced antenna
c) Folded dipole antenna is a dipole antenna with its end folded back
forming a loop
d) Balun is used at the feeder when unbalanced feed is used in the
folded dipole
14. In which of the following type of folded dipole the number of

conductors is varied?
a) Multi conductor folded dipole
b) Unequal conductor folded dipole
c) Both multi conductor and unequal conductor
d) Neither multi conductor nor unequal conductor
15..The impedance at the center of the antenna is known as?

a) Characteristic impedance
b) Radiation resistance
c) Transmission impedance
d) Recovery resistance
16.What happens when the radiation resistance of the antenna matches
the characteristic impedance of the transmission line?
a) No transmission occurs
b) No reception occurs
c) SWR is maximum
d) SWR is minimum
17. What does the beam width of an antenna tell us?

a) Signal strength
b) Signal power
c) Directivity
d) Degradation
18. What is the power radiated by the antenna with gain called as?
a) Critical power
b) Transverse power
c) Effective radiated power
d) Transmitted power
19. Which of the following antennas produce a vertical radiation pattern?

a) Dipole antenna
b) Yagi antenna
c) Marconi antenna
d) Hertz antenna
20) Which among the following defines the angular distance between
two points oneach side of major lobe especially when the radiation drops
to zero? -----------
a. Half power beam width (HPBW)
b. First null beam width (FNBW)
c. Side lobe level (SLL)

d. Front to back ratio (FBR)
21) What is the nature of radiation pattern of an isotropic antenna?
a. Spherical
b. Dough-nut
c. Elliptical
d. Hyperbolic
22). On which of the following factors does the overall impedance of the
unequal conductor folded dipole depends?
a) Only thickness of conductors
b) Space between conductors
c) Radiation resistance of the dipole
d) Radii, radiation resistance and space between conductors.
23). The length of the reflector compared to the driven element is

______
a) Greater
b) Smaller
c) Independent to each other
d) Depends on the type of driven element
24).The shape of the patch in rectangular Microstrip antenna is ____

a) Rectangular
b) Circular
c) Cylindrical
d) Elliptical
25. which of the following is called as the source placed at the focus?
a) Feed radiator
b) Reflector
c) Secondary radiator
d) Primary / reflector

MCQ (Unit4) - Latest

Uploaded by

Copyright:

Available Formats

MCQ (Unit4) - Latest

Uploaded by

Document Information

Original Description:

Original Title

Copyright

Available Formats

Share this document

Share or Embed Document

Sharing Options

Did you find this document useful?

Is this content inappropriate?

Copyright:

Available Formats

MCQ (Unit4) - Latest

Uploaded by

Copyright:

Available Formats

UNIT-4 MCQ......

SUBJECT:A&P III ECE

2. In which of the following type of antenna a patch is created during

3. Microwave frequency range is-------

4). The radiation resistance of folded dipole of equal radii is---------

5). The radiation resistance of folded dipole of unequal

7). The radiation pattern of helix in Axial mode is-----------

8). The radiation pattern of helix in Normal mode is-----------

13. Which of the following statement is not correct?

14. In which of the following type of folded dipole the number of

15..The impedance at the center of the antenna is known as?

17. What does the beam width of an antenna tell us?

19. Which of the following antennas produce a vertical radiation pattern?

a. Half power beam width (HPBW)

b. First null beam width (FNBW)

c. Side lobe level (SLL)

21) What is the nature of radiation pattern of an isotropic antenna?

23). The length of the reflector compared to the driven element is

24).The shape of the patch in rectangular Microstrip antenna is ____

You might also like