Westlock 316 Silver Bullet

Download as pdf or txt
Download as pdf or txt
You are on page 1of 3

AccuTrak™ 316 Silver Bullet

Explosionproof Linear Position Sensor - ATEX/IEC

A Magnum hermetically-sealed proximity switch in a


stainless steel enclosure which is certified explosionproof.
Double encapsulated in an epoxy resin and shock
absorbent polymer.
Features
• Available with SPDT or DPDT switches.
• Mounting kits available for most control
and knife gate valves.
• Standard 6 m lead allows remote
mounting if required.
• Cable marked as appliance wiring
material UL758.
• Rhodium contact option for use with low
power I/O’s for longer contact life.
• Highly resistant to shock and vibration
stresses, chemical and environmental
exposure.

Technical data
Agency approvals
Area classification (ATEX/IEC) Ex II 2 GD Ex d IIC T* Gb
Ex tb IIIC T* D6 IP6X
Enclosure standards (IEC) IP66/67 (with suitable glanding)
IPx8 (with suitable glanding)

Switches
Magnum, SPDT hermetically sealed switches
Magnum, DPDT hermetically sealed switches
Enclosure
Stainless steel

www.westlockcontrols.com
Copyright © Westlock. All rights reserved WESTDS-09039-EN-1302
AccuTrak™ 316 Silver Bullet
Explosionproof Linear Position Sensor - ATEX/IEC

Dimensions

91,95
(3,620)

17,78 42,42
(0,700) (1,670)
(1,155)
25,40

5/8-18 UNF
1/2 NPT OR
M20 CONDUIT
ENTRY

RED RED
NC WHITE
NC WHITE
NO C BLACK C BLACK
NO GREEN (GND)
ORANGE
NC
BLUE
C BROWN SPOT FROM C
NO
GREEN (GND) (NORMALLY OPEN)
DROT FROM CC
(NORMALLY OPEN)

Dimensions in metric, imperial dimensions (inches) in parenthesis

Maintenance
All Silver Bullets are bolted to heavy duty stainless steel brackets. Sensor triggering is
accomplished by stainless steel encapsulated ferromagnetic actuators. Eventually, as valve
seats wear, a slight re-adjustment of position sensors becomes necessary.

Technical specifications
Enclosure 316 stainless steel
Temp. range -40°C to +104°C (-40°F to +220°F)
Operating time 3.0 ms
Repeatability 0.13 mm (0.005 inch)
Hysteresis 0.76 mm (0.030 inch)
Hermetic seal Glass (vacuum)
Sensing 2.54 mm (0.100 inch) end sensing
Electrical rating
Tungsten SPDT Form C (normally open)
3 A / 120 V AC
1.5 A / 240 V AC
0.20 A / 24 V DC
Rhodium SPDT Form C (normally open)
1 A / 24 V DC
0.20 A / 120 V AC
Cable
Wire diameter 18AWG
Jacket diameter SPDT switch 6.1 mm +/- 0.25 mm (0.239 inch +/- 0.010 inch)
Jacket diameter DPDT switch 9.1 mm +/- 0.25 mm (0.360 inch +/- 0.010 inch )
Appliance wiring material UL758

Notes
Hazardous area classification
Please see our data sheet for further information on the global standards affecting the
specification and installation of equipment in hazardous areas.

Copyright © Westlock. All rights reserved Page 2


AccuTrak™ 316 Silver Bullet
Selection Guide

Base model
316SB Silver Bullet position sensor
Switch design
S Single Pole Double Throw
D Double Pole Double Throw
Contact material
T Tungsten
R Rhodium
Conduit
M M20 x 1.5 - Approved to ATEX & IECEx
N 1/2” -14 NPT - Approved to ATEX, IECEx & c UL us
Length of Flying Lead
XXX Flying Lead Length in metres
020 6.00 metres
Special Feature
AAA Standard
XXX Special variants

Example Code: 316SB-STM-020-AAA = 316 Silver Bullet, SPDT, Tungsten contacts, M20 conduit, 6 m flying lead & standard build.

US/Canada: Saddle Brook, NJ South America: Sao Paulo, Brazil Europe: Kent, England Asia: Singapore
Ph: +1 201 794 7650 Ph: +55 11 2588 1400 Ph: +44 1892 516277 Ph: +65 6768 5850
Fax: +1 201 794 0913 Fax: +55 11 2588 1410 Fax: +44 1892 707620
E-mail: [email protected] E-mail: [email protected] E-mail: [email protected] E-mail: [email protected]

Copyright © Westlock. All rights reserved Page 3

You might also like