01 - MGS2500C6CP L51M68 20190307

Download as pdf or txt
Download as pdf or txt
You are on page 1of 4

MITSUBISHI MGS SERIES

DIESEL GENERATOR SET


60Hz/1800 rpm/380V

MGS2500C
POWER RATING (0.8 P.F.) MODEL CODE
PRIME 1720 kW 6CP-L51M68

The photograph is MGS2000B


Voltage Variation
■ Standard Voltage 3Phase 4 Wires
380V
■ Voltages Available 3Phase 4 Wires
380, 400 and 416V
Note: Outputs for optional voltages may differ from standard output mentioned above.

CONDITIONS & DEFINITIONS


Prime【PRP】: Code:CP
Applicable for supplying power with varying load instead of the utility for an unlimited time. +10% overload is allowed in
accordance with ISO3046/1. Prime power in accordance with ISO15550,ISO3046/1,JIS8002-1,DIN6271 and BS5514.
Prime power in accordance with ISO8528.

Conditions:
Engine ratings are based on SAE J1349 standard conditions and also apply at ISO3046/1, DIN6271 & BS5514 standard
conditions.
Fuel rates: based on ASTM D975, BS2869 and on fuel oil of 35° API (16°C or 60° F) gravity having a LHV of 42,780 kJ/kg
(18,390 Btu/lb.) when used at 29°C (85° F) and weighing 838.9 g/liter (7.001lbs./U.S. gal.).

Note: * Please consult with your nearest Mitsubishi MGS dealer for additional rating requirements.

DIMENSION (Reference Data)

PRIME
1720 kW
Overall dimensions L : Length mm 5775
W : Width mm 2395
H : Height mm 3460
Total Weight (Dry) kg 14400
Total Weight (Wet) kg 15090

MGS2500C (1/4) Rev/0319


MITSUBISHI MGS SERIES
DIESEL GENERATOR SET
MGS2500C

MGS SERIES DIESEL ENGINE: MITSUBISHI S16R-PTAA2


V-16, 4 stroke-cycle water-cooled, turbocharged and air-to-air cooling system
ENGINE SPECIFICATIONS & TECHNICAL DATA

Bore mm 170
Stroke mm 180
Displacement L 65.37
Piston speed m/sec. 10.8
Compression ratio 14.0
Lubricating oil capacity L 230
Coolant capacity without/with radiator L 170/399
Coolant pump external resistance m water 3.5
Coolant pump flow rate L/min 1850
Cooling fan airflow rate m3/min 2500
Cooling fan air flow restriction kPa 0.1
Ambient air temperature ℃ 40
Allowable exhaust back pressure kPa 6.0
Exhaust flange size (internal diameter) mm 350

ENGINE OPERATING DATA

PRIME
1720 kW
Gross Engine Power* kWm 1895
Brake mean effective pressure MPa 2.0
Regenerative absorption kW 192
Noise Level at 1 m dB(A) 114
(excluding: intake, exhaust & fan)
Fuel consumption load 100%* L/hr. 463
Fuel consumption load 75%* L/hr. 355
Combustion air inlet flow rate m3/min 175
Exhaust gas flow rate m3/min 464
Exhaust gas temperature ℃ 530
Heat rejection to coolant kW 716
Heat rejection to exhaust kW 1643
Heat rejection to atmosphere from engine kW 154
Heat rejection to atmosphere from generator kW 91
* WITH FAN basis.

Deration for engine

Note: Please consult with your nearest Mitsubishi MGS dealer

ENGINE STANDARD EQUIPMENT


Aftercooler
Turbocharger filter (For MGS-B, HV stand-by and prime)
Paper element type filter (For MGS-C, HV PRP continuous)
Structure steel base
Crankcase breather
Charging alternator
Lubricating oil cooler
Fuel filters, full flow paper element
Fuel transfer pump, gear driven, plunger type
Electronic type governor
Jacket water heater *
Jacket water pump, gear driven
Lubricating oil filter, full flow paper element
Lubricating oil pump, gear driven
Exhaust dry manifold
Radiator, blower fan, fan drive
Manual shutoff
24V DC electric starting motor
* Depending on the model, it becomes optional setting.

MGS2500C (2/4) Rev/0319


MITSUBISHI MGS SERIES
DIESEL GENERATOR SET
MGS2500C

MGS SERIES 7310 MKⅡ GENERATOR CONTROL PANEL


Features
MGS standard 7310 MKⅡ programmable microprocessor generator control panel provides the following functions
◆ Start and stop control
◆ Engine and generator measurement items on LCD display and LED on the front panel for operation status indication
◆ Engine and generator shutdown and warning protection
◆ Generator breaker control
◆ Expansion module for additional output and input
◆ RS485 and RS232C communication for remote monitoring

Mounting
Fabricated cubicle mounted on individual bracket with anti-vibration isolator

Instrument and control accessories


■ Generator running indicator ■ Selector switch (ACTIVE, PANEL LOCK, STOP/RESET)
■ Manual button ■ Mute alarm button
■ Auto button ■ Menu navigation button
■ CB open button (Manual only) ■ Common alarm indicator
■ CB close button (Manual only) ■ Voltage adjuster
■ Manual start button ■ Speed adjuster
■ Manual Stop/Reset button ■ Emergency stop pushbutton

Measured items on LCD display


■ Generator volts L1-N, L2-N, L3-N ■ Battery volts
■ Generator volts L1-L2, L2-L3, L3-L1 ■ Engine hours run
■ Generator amps L1, L2, L3 ■ Generator Load kW, kVA, kVar
■ Generator Frequency Hz ■ Generator Load kWh, kVAh, kVarh
■ Engine speed RPM ■ Power Factor
■ Engine oil pressure (PSI & Bar & kPa) ■ Generator Phase Sequence
■ Engine cooling water temperature (°C & °F)

Shutdown and Warning items on LCD display


■ High coolant temperature : shutdown and warning ■ Generator high current : shutdown (IDMT) and warning
■ Low oil pressure : shutdown and warning ■ Over voltage (AC) : shutdown and warning
■ Fail to start : shutdown ■ Under voltage (AC) : shutdown and warning
■ Over-speed : shutdown and warning ■ Over frequency : warning
■ Under-speed : shutdown and warning ■ Under frequency : warning
■ Loss of speed signal : shutdown ■ Overload : warning
■ Fail to stop : warning ■ Winding temperature high (U, V, W) : warning *1
■ Over voltage (DC) : warning ■ Bearing temperature high : warning *1
■ Under voltage (DC) : warning ■ Electrical trip
■ Lubrication oil filter clogged : warning ■ Emergency stop : shutdown
■ High oil temperature : shutdown and warning *1 *2
■ Oil pressure sender open circuit : shutdown
■ Charge fail : warning
■ Exhaust gas temperature high : warning *1
■ Coolant level low : warning *1
■ High crankcase internal pressure : shutdown *1
*1 : MGS-C, HV continuous are applicable as standard. The others are applicable as option.
*2 : MGS2700 and MGS2800 are applicable as standard. The others are applicable as option.

Operation status indicated by LED


■ Remote start present
■ Generator ready
■ Lubrication oil filter clogged
■ Electrical trip

MGS2500C (3/4) Rev/0319


MITSUBISHI MGS SERIES
DIESEL GENERATOR SET
MGS2500C

MGS SERIES AC GENERATOR MODEL: MG-L51M68


Features
MGS original design, single bearing, 4 pole, screen protected, self excited, self regulating and brushless with fully
connected damper windings, salient pole rotors, A.C. exciter and rotating rectifier unit. Direct coupled to engine and
regreaseable bearing, direct drive centrifugal blower.
Enclosure: Drip-proof IP23
Winding System
Standard 6 wire winding provides 3 phase voltage. All windings are impregnated in vacuum pressure impregnated with a
special polyester resin.
Overspeed capability: 125% for 2 minutes
Insulation: Class 'H'
Temperature rise: 105℃
Voltage Regulator
Fully sealed, single phase RMS sensing AVR with built-in protection against sustained over-excitation.
Voltage regulation: Less than +/- 0.5% from no load to full load at any power factor between 0.8 lagging and 1.0
allowing for a 4% engine speed variation
Voltage adjustment: +/- 6%
Wave form: Less than 5% deviation
AREP and PMI
Separately excited system which provide isolated power supply for the AVR – sustain short circuit current approximately
250-300% under fault condition.
Electrical Design
In accordance with ISO 8528-3, IEC60034-1/BS EN60034-1, VDE0530, NEMA MG1-32, CSA22-2-100 and UL1446.

Telephone Influence Factor (TIF): Less than 50

Gen Set Option Features


■ ENGINE ■ GENERATOR
Air Cleaner, paper element dry type Space Heater
(For MGS-B, HV stand-by and prime only) Power Factor Regulator
Battery Kit
Battery Charger ■ CONTROL PANEL
Anchor Bolts Diesel Generator Integrated Communication Synthesizer
(DGICS-MII)
■ FUEL Auxiliary Control Panel
Fuel Day Service Tank Cross Current Compensate Transformer (CCT)
Remote Monitor Interface
■ COOLING 2157 expansion unit (Output signal module)
2130 expansion unit (Input signal module)
2133 expantion unit (RTD/Thermocouple input module)
■ SWITCHGEAR
Circuit Breaker MCCB & ACB
Reverse Power Relay
■ LUBRICATION
Lub. Oil Level Regulator

■ EXHAUST
Exhaust Silencer
Exhaust Flexible Pipe

No. 3, Tuas Avenue 12, Singapore 639024


Republic of Singapore
Phone:65-6862 2202 Fax: 65-6862 5728
URL: http://www.mhiesa.com/

Mitsubishi Heavy Industries Engine System Asia Pte Ltd, serves for the customers with improved products continually.
Therefore specification and some materials will be changed without notice.
The International System of units (SI) is used in this publication.

MGS2500C (4/4) Rev/0319

You might also like