Scribd
Upload
173 views6 pages

VMIII & Remote Panel Firmware Upgrade Process

The document provides steps to upgrade the firmware of a VMIII remote panel and unit: 1. Connect the unit and PC with an RS-232 or USB cable and power the unit without turning it off. 2. Use a tool to select the correct COM port or USB, choose the firmware file, and click "Update Firmware" which will upgrade the firmware over about 10 seconds. 3. After successful upgrade, check the firmware version on the LCD matches the new version.

Uploaded by

Zia Bugti Baloch
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
173 views6 pages

VMIII & Remote Panel Firmware Upgrade Process

The document provides steps to upgrade the firmware of a VMIII remote panel and unit: 1. Connect the unit and PC with an RS-232 or USB cable and power the unit without turning it off. 2. Use a tool to select the correct COM port or USB, choose the firmware file, and click "Update Firmware" which will upgrade the firmware over about 10 seconds. 3. After successful upgrade, check the firmware version on the LCD matches the new version.

Uploaded by

Zia Bugti Baloch
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 6

VMIII & Remote Panel Firmware Upgrade Process

 Preparation for firmware upgrade operation


Step1. Connect the unit and the PC via RS232 cable or USB cable, and utility power to AC
terminal, switches AC breaker on. Please refer to picture as below.
NOTE: There is no NEED to turn off the unit when updating the LCD program. KEEP the unit
up and running and make sure the LCD is lit normally.

Figure 1-1

Figure 1-2

Step2. If use RS232, please check the COM Port Number as below pictures.
NOTE: Make sure all application communication software using this COM port is turned off.
The application software include some UPS monitoring software.

1
Figure 2

Figure 3

Figure 4

2
VMIII Firmware Upgrade Process

Step1. Execute “UPSReflashTool.exe”. Please refer to below picture.

Figure 5

Step2. If use RS232, please select “com port number”, if use USB, please select “USB”. Click
“File” to select file. Please refer to below picture.

(com port) (USB)


Figure 6

3
Step3. Open “VM3.hex”. Please refer to below picture.

Figure 7

Step4. Click “Update Firmware” to upgrade firmware. Please refer to below picture.

Figure 8

4
Please wait for about ten seconds. Upgrade firmware of MCU in progress.

Figure 9

Step5. After the firmware upgrade successful, you can see the information as below. Click
“Exit” to stop tool. Please refer to below picture.

Figure 10

5
Step6. Please check the firmware on the Identification page of the LCD. Please make sure
the new firmware version of the Display U1 is 41.15

You might also like