MSDS Microbiological Control DG 402

DG 401 MSDS : Microbiological Control Cooling Water Treatment
CV. Arya Bintang Perkasa
Material Safety Data Sheet

DG 402
SCALE AND CORROSION INHIBITOR
SECTION 1. IDENTIFICATION OF THE PREPARATION AND THE COMPANY

Product Name DG 402
Company Name CV. ARYA BINTANG PERKASA
Office :
Jalan Kahuripan 1 No.15, Cibodasari, Karawaci
15138 Tangerang – Banten
Second Office :
Phone No: ( 021 ) 5566 5717
Pondok Mitra Lestari Blok C9 No.4, Pekayon
17422 Bekasi – Jawa Barat
Phone No: ( 021 ) 8273 5376
SECTION 2. COMPOSITION / INGREDIENTS

CHEMICAL DESCRIPTION:
Organosulfur compounds
This product is classified as Non-Hazardous
SECTION 3. HEALTH HAZARD

This product as supplied is classed as non-hazardous; however prolonged
contact may cause skin or eye irritation.
SECTION 4. FIRST AID MEASURES

General Instructions: In all cases of doubt, or when symptoms persist, seek
more advice. Remove from exposure, rest and keep warm. seek medical
attention, treat symptomatically.
Skin Contact: Drench affected area with plenty of water, remove contaminated
clothing immediately Seek medical attention.
Material Safety Data Sheet Page 1

Eye Contact: Irrigate the eyes thoroughly with water for at least 15 minutes,
holding the eyelids apart if necessary. Obtain medical attention.
Ingestion: Wash out mouth with water and give plenty of water to drink. DO
NOT induce vomiting. Obtain medical attention.
SECTION 5. FIRE FIGHTING MEASURES
Extinguishing Media : Non combustible. Use extinguishing media appropriate
to surrounding fire conditions
Unsuitable Extinguishing Media: None Hazardous Combustion Products: Emits
toxic fumes under fire conditions
Special equipment for firefighting: Wear self contained breathing apparatus
when fight
SECTION 6. HEALTH HAZARD DATA

THRESHOLD LIMIT VALUE
Not established for mixture
EFFECTS OF OVER EXPOSURE

ACUTE – ( Short term Exposure )
EYES : Cause irritation or burns, may damage eye tissue
SKIN : May cause irritation and redness
INHALATION : May cause irritation to throat and respiratory
tract,headacheand nausea
INGESTION : May cause irritation to mouth and throat, nausea and
vomiting.
CHRONIC ( Long Term Exposure )

No chronic human data available
TARGET ORGANS
None known
EMERGENCY & FIRST AID PROCEDURES

INHALTION : Move to fresh air, seek medical attention of respiratory,
Irritation develops or breathing becomes difficult.
EYE CONTACT : Immediately rinse with water. Remove any contact lenses.
Wash eyes at least 15 minutes with large amounts of water holding lids apart.
If physician is not available, flush for additional 15 minutes. Get immediate
medical attention.

SKIN CONTACT : Wash off thoroughly with soap and water. Remove and
clean contaminated clothing and shoes. Seek medical attention if irritation
develops or persist.
INGESTION : Give 3-4 glasses of water, but do not induce vomiting. Seek
medical attention immediately.
SECTION. 7 HANDLING AND STORAGE

Handling : Do not get into eyes, skin or clothing.
Avoid prolonged or repeated exposure
Storage : Keep container tightly closed. Store in a cool dry place
OTHER PRECAUTIONS
Always read and follow all label directions. Store only in original labeled
containers. Keep out reach of children.
SECTION. 8 PHYSICAL AND CHEMICAL PROPERTIES

Appearance : Liquid
Solubility in water : Soluble in water
Odour : Organic
Color : Brown
pH @ 10% :6–7
Specific gravity ( H2O : 1 ) : 1.280
Boiling Point/ ( 0F ) : 200 - 220
Melting Point/Melting Range : N/A
Flash Point : N/A
Flammability : N/A
Auto flammability : N/A
Evaporation rate ( BU AC = 1 ) : N/A
Viscocity : N/A
Vapors Pressure : N/A
Vapors Density ( AIR – 1 ) : 1.260
SECTION 9. ECOLOGICAL INFORMATION

Environmental Effects : No adverse effect
Mobility : n/a
Degradability : n/a
Bioaccumulative Potential : n/a
Marine Pollutant : No

SECTION 10. TRANSPORT INFORMATION

This product is classified as Non-Hazardous
SECTION 11. REFERENCES

1. Threshold limit values for chemical substances and physical agents and
biological exposure indices,
ACGHI, 2010 - 2011
2. Vendor’s MSDS
Short term exposure limit ( TWA ) listed as final rule limits published in the
federal register/ vol. 40 No.19,11-10-12
The information contained herein is based on data considered accurate in light

of current formulation, however, no warranty is expressed or implied
regarding the accuracy of this data or results to be obtained from the use
thereof.
DG chemicals assumes no responsibility for personal injury or property damage
caused by the use, storage or disposal of the product in a manner not
recommended on the product label. Users assume all risks associated with
such unrecommended use, storage, or disposal of the product.

MSDS Microbiological Control DG 402

Uploaded by

Copyright:

Available Formats

MSDS Microbiological Control DG 402

Uploaded by

Document Information

Copyright

Available Formats

Share this document

Share or Embed Document

Sharing Options

Did you find this document useful?

Is this content inappropriate?

Copyright:

Available Formats

MSDS Microbiological Control DG 402

Uploaded by

Copyright:

Available Formats

DG 401 MSDS : Microbiological Control Cooling Water Treatment

CV. Arya Bintang Perkasa

Material Safety Data Sheet

SECTION 1. IDENTIFICATION OF THE PREPARATION AND THE COMPANY

SECTION 2. COMPOSITION / INGREDIENTS

SECTION 3. HEALTH HAZARD

SECTION 4. FIRST AID MEASURES

Material Safety Data Sheet Page 1

SECTION 6. HEALTH HAZARD DATA

EFFECTS OF OVER EXPOSURE

CHRONIC ( Long Term Exposure )

EMERGENCY & FIRST AID PROCEDURES

Material Safety Data Sheet Page 2

SECTION. 7 HANDLING AND STORAGE

SECTION. 8 PHYSICAL AND CHEMICAL PROPERTIES

SECTION 9. ECOLOGICAL INFORMATION

Material Safety Data Sheet Page 3

SECTION 10. TRANSPORT INFORMATION

SECTION 11. REFERENCES

The information contained herein is based on data considered accurate in light

Material Safety Data Sheet Page 4

You might also like