Scribd
Upload
47 views1 page

Cluster Programming Steps

The document provides instructions for connecting an STM programmer, opening a .bin file, and starting the programming and verification process.

Uploaded by

vinayak deshpande
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
47 views1 page

Cluster Programming Steps

The document provides instructions for connecting an STM programmer, opening a .bin file, and starting the programming and verification process.

Uploaded by

vinayak deshpande
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 1

CLUSTER PROGRAMMING

1. Connect the STM programmer according to the diagram sent.


2. Click on target and then click on connect. Once it is connected the data bytes will be visible on the
main screen.
3. Go to target-settings and make sure the mode is in Hot plug and debug in low power mode is
enabled.
4. Click on file - click on on open- browse for the shared.bin file and open it.
5. Click on target- click on Program Verify - click on Start

You might also like