Assignment: Submitted By: Department: Bs MLT (B) Semester: Roll No: Submitted To: Subject

Download as docx, pdf, or txt
Download as docx, pdf, or txt
You are on page 1of 3

Assignment

Submitted by:
Muhammad Abdullah
Department:
BS MLT (B)
Semester:
6th
Roll no:
68
Submitted to:
Mam Umbreen Shabbir
Subject:
Serological Techniques

Minhaj University Lahore

Serial dilution
Definition:
Serial dilution, as the name suggests, is a series of sequential dilutions that are
performed to convert a dense solution into a more usable concentration.In simple
words, serial dilution is the process of stepwise dilution of a solution with an
associated dilution factor.
Calculation:
Serial dilution involves the process of taking a sample and diluting it through a series
of standard volumes of sterile diluent, which can either be distilled water or 0.9 %
saline.Then, a small measured volume of each dilution is used to make a series
of pour or spread plates.
Depending on the estimated concentration of cells/organisms in a sample, the extent
of dilution is determined. For e.g., if a water sample is taken from an extremely
polluted environment, the dilution factor is increased. In contrast, for a less
contaminated sample, a low dilution factor might be sufficient.
Serial two-fold and ten-fold dilutions are commonly used to titer antibodies or
prepare diluted analytes in the laboratory.
The dilution factor in a serial dilution can be determined either for an individual test
tube or can be calculated as a total dilution factor in the entire series.
The dilution factor of each tube in a set:

For a ten-fold dilution, 1 ml of sample is added to 9 ml of diluent. In this case, the


dilution factor for that test tube will be:

After the first tube, each tube is the dilution of the previous dilution tube.
Now, for total dilution factor,Total dilution factor for the second tube = dilution of
first tube × dilution of the second tube.
Example:
For the first tube, dilution factor = 10-1 (1 ml added to 9 ml)
For the second tube, dilution factor = 10-1 (1ml added to 9 ml)
Total dilution factor = previous dilution × dilution of next tube
= total dilution of 10-1 × 10-1 = 10-2

You might also like