Scribd
Upload
241 views2 pages

Smart Atm Security Syste Based On Arduino and Iot

This system uses sensors like vibration, temperature, and accelerometer sensors attached to an ATM to detect robbery attempts. If triggered, the system will automatically shut the ATM door, release chloroform gas inside to sedate the thief, sound an alarm, and send SMS alerts to police and bank managers. The door can then only be opened by entering a password from an authorized person to apprehend the thief.

Uploaded by

Akmal Khan
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
241 views2 pages

Smart Atm Security Syste Based On Arduino and Iot

This system uses sensors like vibration, temperature, and accelerometer sensors attached to an ATM to detect robbery attempts. If triggered, the system will automatically shut the ATM door, release chloroform gas inside to sedate the thief, sound an alarm, and send SMS alerts to police and bank managers. The door can then only be opened by entering a password from an authorized person to apprehend the thief.

Uploaded by

Akmal Khan
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 2

SMART ATM SECURITY SYSTE BASED ON

ARDUINO AND IOT.


1. This system uses Arduino based embedded system to process real time data collected
by the vibration sensor, accelerometer and temperature sensors. Once the robbery is
detected, the Siren will start alerting the public. The door of the ATM will automatically
shut close.
2. Solenoid valve is used to leak the gas (Chloroform) inside the ATM chamber to bring the thief
into unconscious stage once he inhales the dose defined.
3. GSM Modem is used to send message to the nearby police station, corresponding bank manager
and Security Officers. Once the bank officials or Police come, they can disable the system by
entering a password then open the ATM door and catch hold of the Thief.

METHODOLOGY.
 Vibrations: Vibration sensors attached to the ATM machine will trigger when the robber
tries to cut the ATM machine using any of cutting tools such as hacksaw or any drilling
machine. This generates a lot of vibration, more than the average activates in the ATM
booth.
 Temperature sensor [LM35]: Few of them are placed just behind the cash withdrawal
chamber. There is a possibility that the robber can use a gas cutter to cut through the cash
chamber rather than using a cutter, then temperature could easily exceed 400 degree
centigrade. The output of sensor is in the form of analog voltage.
 Accelerometer [ADXL335]: The displacement of the machine measured by the 3 axis
accelerometer. Finally there is also a chance that he can try and lift the whole of the ATM
machine. Hence once the predefined threshold level is crossed the microcontroller is trigger
indicating the ATM machine is being tried to shift out of its place.
 • If either of the above three things were to happen there is a trigger to the Arduino, the
door of the ATM is automatically shut down. The chloroform gas is released into the
chamber.
 The next step, the siren goes on, alerting the public. An SMS is sent to the concerned
persons using the GSM module connected to the microcontroller. The SMS could be sent to
police, bank manager and the security guard.
 Now there is need of the bank manager or the police to come and open the door and
apprehend the thief. Once the code is accepted, the door is ready to be opened.

DEVICES USED.
 Arduino
 BUZZER
 GSM MODULE
 LCD
 ARDUINO
 SPRINKLER
 SOLENIED VALVE
 DHT11 SENSOR
 ADXL35 SENSOR
 PUSH BUTTONS
 KEY PAD

You might also like