Scribd
Upload
365 views1 page

Djj30122 - Computer Aided Design 2 Practical Task 1: Name: Matric No.: Class

This document provides instructions for a computer aided design (CAD) practical task. Students are asked to design a figure using CAD software, ensuring the design has correct dimensions and scale. The figure is not specified, but the dimensions should be measured in inches. The task is worth 20 total points and evaluates two learning outcomes.

Uploaded by

Gnabry
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
365 views1 page

Djj30122 - Computer Aided Design 2 Practical Task 1: Name: Matric No.: Class

This document provides instructions for a computer aided design (CAD) practical task. Students are asked to design a figure using CAD software, ensuring the design has correct dimensions and scale. The figure is not specified, but the dimensions should be measured in inches. The task is worth 20 total points and evaluates two learning outcomes.

Uploaded by

Gnabry
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

CLO/GSA MARKS

CLO1/LD1 /10
DJJ30122 – COMPUTER AIDED DESIGN 2 CLO2/LD2 /10
PRACTICAL TASK 1
NAME :
MATRIC NO. :
CLASS : TOTAL /20

Design the figure below using CAD software with correct dimension and scale. (P3)

Dimension: Inch
Page 1 of 1

You might also like