Pf6K VW XML Configuration FW. 2.8.5.39 XML 2.1.R.3.6
Pf6K VW XML Configuration FW. 2.8.5.39 XML 2.1.R.3.6
VW XML Configuration
FW. 2.8.5.39
XML 2.1.R.3.6
Benjamin Harbich, 23.10.2018
AFTER CHANGE
RESTART CONTROLLER!
8
• ToolsTalk …
27
• ToolsTalk …
28
• Es wird mindestens
ToolsNet 8.6 zur
Rapportierung benötigt.
29
• Kleinster einstellbarer
Wert ist für <M+> „0,01
Nm“
• „0,00 Nm“ wird nicht
als Fehler angezeigt
aber verursacht ein
invalides Programm
und wird erst bei
Verwendung im
MasterPC angezeigt.
41
• Kleinster einstellbarer
Wert ist „0,01 Nm“
• „0,00 Nm“ wird nicht
als Fehler angezeigt
aber verursacht ein
invalides Programm
und wird erst bei
Verwendung im
MasterPC angezeigt.
42
A tightening step of strategy “AW” is configured in TT2 by a “Tighten to Angle” step. The following settings
needs to become applied:
• 4-step tightening
program, ending up with
an torque- step:
It is very important to adjust the monitors and restrictions for each step added manually. By
default TT2 is adding some monitors / restrictions that are not needed and some are missing.
Furthermore it is strongly recommended by R&D, always to define the step category.
52
• 4-step tightening
program, ending up with
an angle- step:
It is very important to adjust the monitors and restrictions for each step added manually. By default
TT2 is adding some monitors / restrictions that are not needed and some are missing. Furthermore
it is strongly recommended by R&D, always to define the step category.
COMMITTED TO SUSTAINABLE PRODUCTIVITY